|
| 1 | 1.) Construction ofNew AnganwadiBuilding Near School H/o Chinnamanaickenpalayam |
| 2 | Earth work Excavation for Foundation in all soilsand sub Soil as per SS2 for foundation etc., completed SS 2B |
| 3 | Collection and supply of sandand filling in to the basement including cost and conveyanceto the site and all labour charges for fillingas per standard speecifications |
| 4 | Collection and supply of 40mm metaland filling in to the basement including cost and conveyanceto the site and all labour charges for fillingas per standard speecifications |
| 5 | Collection and supply of 20mm metaland filling in to the basement including cost and conveyanceto the site and all labour charges for fillingas per standard speecifications |
| 6 | Cement concrete 1:4:8 mix using 40mm ISS metal including cost andconveyance of all materials to site and all labour charges for mixing, laying and curing etc completefor 10 cum. |
| 7 | Brick work in cement mortar 1:5 (One cement and five sand) using country bricks ground moulded of size 8 3/4\" x4 1/4\" x2 1/4\"cm. For the following including curing,etc., complete complying with standard specification |
| 8 | Supplying and erecting shuttering including necessary supports for plane surface in foundation and basement and in all floors for RCC column footings, column, pedestals, plinth beam, grade beams, raft slabs, staircase steps, bed blocks, critical pier etc., using mild steel sheets of size 90 x 60 cm & 10 gauge stiffened, welded with steel angles of size 25mm x 25mm x 3mm for boarding laid over silver oak (country wood) joists of size 10cm x 6.5cm spaced at about 90 cm centre to centre and supported by casuarina props of 10cm to 13cm dia spaced at 75cm centre to centre complete complying with standard specification and as directed (S.I.155) - Lintel Beam |
| 9 | Centering Sides |
| 10 | Supplying fabricating and placing in position mild steel or nibbled for steel for all reinforced cement concrete works as per the desing given including cost of steel and binding wire in all floors etc. complete complying with standard specification (MS rods or RTS bars will be supplied department sally at section stores and cost will be recovered at issue rate). The binding wire shall be supplied by the Contractor. |
| 11 | Reinforced cement concrete 1:1.5:3 mix using 20mmISS metal including cost and conveyance of all materials to site and all labour charges for mixing, laying, and curing etc complete |
| 12 | Supplying and applying of two coats of putty of 3mm thick over the exposed RCC surface of ceiling including finishing the joints smoothy with grinding machine and the surface shall be thoroughly cleaned out of dust and scrubbing. The Surface shall then be allowed to dry for atleast 48 hours. It shall then be sand papered (waterproof abrasive sheet) to give a smooth and even surface. Any unevenness shall be made good by applying 1st coat of putty mixed with water on the entire surface including filling up the undulations and applying 2nd coat of putty after 6 hours of 1st coat of putty and then sand papering (waterproof abrasive sheet) the same after it is dry and finishing the surface smoothly, etc., complete complying with standard specifications and as directed by the Departmental Officers. The rates are inclusive of hire charges for grinding machine with wheel, cost of sand paper (waterproof abrasive sheet), cost of putty blade, labour charges for grinding the joints and sand papering, two coat of putty, scrapping the putty area to level the surface smooth, etc., complete]. The Putty should be got approved by the Executive Engineer before use on work. (Based on SoR 2023-24) Wall putty Powder: (10 sqm/10x20 kg= 20Kg) |
| 13 | Plastering with CM 1:5, 12mm thick. including curing etc., complete complying with standard specifications and as directed by the departmental officers. |
| 14 | Supply and fixing ofINDIYAN Type Baby Water closetincluding all charges etc., complete |
| 15 | Supply and fixing ofEuropeion Water closetincluding all charges etc., complete |
| 16 | Fabrication and supply of mild steel Door of any size with single leaf outer frame made of 35x35x5 mm equal M.S angle and shutter framemade of 25x25x5 mm M.S angle for horizontal and vertical member with stiffener and fully covered with 18 G plate etc complete.Steel Door D2 (1.10 x 2.40) |
| 17 | Supply cost of steel Door of size 0.90x 2.40 m including all charges etc, complete, complying with standard specification. |
| 18 | Supplying cost of steel Door of size 0.75m x 1.50 m including all charges etc, complete, complying with standard specification. |
| 19 | Fabrication and supply of mild steel window of any size with single leaf outer frame made of 35x35x5 mm equal M.S angle and shutter framemade of 25x25x5 mm M.S angle for horizontal and vertical member with stiffener and fully covered with 18 G plate etc complete - Steel Window 1.20 x 1.30 m |
| 20 | Towards the cost of Supplying & cost of supply of RCC Jollies ofsize 0.45 x 0.45 m |
| 21 | Towards the Cost of Labour charges for steel doors and Windows etc, complete, complying with standard specification.- Steel Door |
| 22 | Steel Window |
| 23 | Supply and fixing Cuddapah slab of 20/30mm thick including labour charges etc complete -1 sq.m |
| 24 | Weathering Course Brick jelly lime concrete using 20mm brick jelly with slacked lime in the ratio of 32:12.5 including cost and conveyance of all materials to site and all labour charges for mixing , laying ,and finishing etc complete |
| 25 | Finished with one course of pressed tiles of size 23x23x2cm with cement mortar 1:3 mix and pointed with the same oiled mortar including cost and conveyance of all materials to site and all labour charges etc complete for 10 Sqm |
| 26 | Providing granolithic floor finish in cement concrete 1:2:4 mix using 10-12mm ISS metal to 25mm thick including cost and conveyance of all materials to site and all labour charges for mixing, laying, curing etc complete for 10 cum. |
| 27 | Paving the floor with best quality Vertified Tiles of size 600 x 600 x 8mmof approved colour, shade and quality laid in cement mortar 1:3 (one cement and three crushed stone M.Sand) 20mm thick in all floors and the top pointed with the white cement mixed same colour pigments etc., complete complying with standard specification.(The make and brand of the tiles should be got approved by Executive Engineer before use on works) |
| 28 | Paving the floor with best quality Pre-polished Concrete anti-skid step Tiles of 20mmcement mortar 1:3 (one cement and three sand) 20mm thick in all floors and the top pointed with the (White cement mixed with colouring pigment) neatly and fixed in position so as to make it perfectly smooth and shining to the alignment etc., complete complying with standard specifications and as directed by the departmental officers. |
| 29 | Dadooing walls with colour designed Glazed tiles of sizes 300mm X200mm X 6mm size of approved make and quality and colour lSet in cement mortar 1:2 (one cement ,two sand) over 10 mm base layer plastering and pointing with white cement neatly as directed. |
| 30 | Distembering two coats oil bound distemberover priming coatinculding cost and conveyance of all materials to site and all loboure charges etccomplete ( Innerwall ) |
| 31 | Plastic Emulsion painting two coatsover priming coatinculding cost and conveyance of all materials to site and all loboure charges etccomplete ( outer wall ) |
| 32 | Painting two coats over new iron works such as steel doors, windows, ventilators, window bars, balustrades etc., withbest approved best quality of synthetic enamel paint of approved colour over the existing priming coat etc., complete complying with standard specifications and as directed by the departmental officers. |
| 33 | Supplying and fixingP.V.C rainwater down fall pipe of 110mm dia with necessary shoes, bends,& clamps etc., |
| 34 | Wiring with 2x1.5 sq.mm.PVC insulated SC unsheathed FRLS copper conductor of1100V grade insuitable PVC rigid pipe concealed in wallandceilingwith PVC accessoires in flush with wall with 3mm thick hylum sheet cover withTW switch box and 5AFT switch and making good of the concealed portion with suitable colour for PVC concealed light ( 6 points per coil) (for rooms like bath, toilet & pumproom, etc.) SD 26 |
| 35 | Wiring with 2x1.5 Sqmm (22/0.3) PVC insulated SC unsheathed Cu. Conductor of 1100 V grade in suitable PVC rigid pipe on wall and ceiling with PVC accessories and with 150x100x113mmTW switch box and 5 A 3 pin non inter locking CS plug with painting of suitable colour with continuous earth wire connection of14 SWG TC wire for Open PVC Plug Point SD.38 |
| 36 | Supply and fixing of 1200 mm ( 48\") AC ceiling fan complete with stepped electronic 300 W regulator with 1 mdown rod on the existing clamp. SD 106 cross arm size 450mm (18\") SD 106 |
| 37 | Supply and fixing of single box type 4\"40 W flu fitting complete with copper choke and condensor with TW round blocks on wall or ceiling with flue tube with PVC Unsheathed coper leads from terminals to the fitting (SD.88) |
| 38 | Supply and fixing of fancy glass shade and 11W CFL for BH point (SD.80) |
| 39 | Supply and fixing of TNEB meter Board suitable for 32A Three phase service connection with 32 A Fuse unit (500V) 32 A neutral link and earth ling (1\"x1/8\" Copper flat) on TW plank of size 600mm x 450mm x 19mm with supporting TW reepers of 1\" thick an either side with painting with suitable bolt and nuts for fixing the TW plank on wall with earth connection and inter connection with 7/20 PVC insulated copper wire from EBV Meter to fues unit(SD.127) |
| 40 | Supply and run of 2 of 1.5 Sqmm (22/0.3) PVC insulated SC unsheathed Cu.Conductor of 1100 v grade in 25mm dia GI Pipe (Class\"B\") Suitably bent at both ends with necessary angle iron upright and end supports for maints (SD.69) |
| 41 | Supply and run of 2 of 4 Sqmm (56/0.3) PVC insulated SC unsheathed Cu.Conductor of 1100 v grade on 7/20 GI Bearer wire for Service connection mains (SD.65) |
| 42 | Supply and fixing of WT Bulk Head Fitting with guard (Philips / Bajaj / Crompton / K. Lite) suitable for incandescent lamp with 60W Bulb (SD.84) |
| 43 | Manufacturing, Supplying and Fixing of Stainless Steel Handrails for staircase near wet riser using 50mm dia 304L GradeStainless Steel pipe of 1.60mm thick will be provided withtubular supports made of 304L Grade Stainless Steel pipe of 25mm dia of 1.60mm thick welded to the railing. Thesupports will be grouted into the wall and provided with 93.00mm thick Stainless Steel circular base plate of 304Grade. The rate shall included for grouting into concrete withnecessary supporting arrangements the hand rail in floorpolishing buffing, bonding, cutting, grinding, conveyance,welding charges, electrical charges, etc. complete |
| 44 | Provisions for drawing Bala painting including all cost and conveyance of men and materials etc.,(the colour and quality should be got approved by the Executive Engineer before use) the rate includes cost of brushes, high scaffolding charges, neat finishing, cost of brushes etc., complete complying with standard specification and as directed by the Departmental Officer |
| 45 | Supply of PVC Tank 1000 lit |
| 46 | Supply of 25 mm PVC Pipe |
| 47 | Supply of 25 mm PVC Elbow |
| 48 | Supply of 25 mm PVC Tee |
| 49 | Supply of 20 mm PVC Tap |
| 50 | Supply of 110 mm PVC Pipe 6 ksc |
| 51 | Supply of 110 mm PVC Elbow |
| 52 | Supply of 110 mm PVC Tee |
| 53 | GST Amount for providing Service to Government Contract Works for the above Construction Works. { GST Amount is the Total GST Amount for total overall quoted amount above this row in column \"BB\" for all works in this package} |
