Tender For Misc Civil Work For Installation Of Open Gym Apparatus Near Shakti Bhawan Main Gate Beside Security Office Parking At Mppmcl Jabalpur - Sor Item No. 15.20:- Dismantling Steel Work In Built Up Sections With Span Upto 10 Meter Including Dismember, Jabalpur-Madhya Pradesh

Tender For Misc Civil Work For Installation Of Open Gym Apparatus Near Shakti Bhawan Main Gate Beside Security Office Parking At Mppmcl Jabalpur - SOR Item No. 15.20:- Dismantling steel work in built up sections with span upto 10 meter including dismembering: Dismantling steel work in built up sections with span upto 10 meter and hieght 5 meter in angles, tees, flats and channels including all gusset plates, bolts, nuts, cutting rivets, welding etc. including dismembering and stacking within 50metres lead. 2 SOR Item No. 15.27.1 :- Dismantling roofing sheet: Dismantling roofing including ridges, hips valleys and gutters etc., and stacking the material within 50 metres lead of: G.S. Sheet. 3 SOR Item No. 2.1 :- Surface dressing: Surface dressing of the ground including removing vegetation and in- equalities not exceeding 15 cm deep and disposal of rubbish, lead up to 50 m and lift up to 1.5 m. in all kinds of soil. 4 SOR Item No. 2.6 :- Excavation on soil: Earth work in excavation by mechanical means (Hydraulic excavator) / manual means over areas (exceeding 30cm in depth. 1.5m in width as well as 10 sqm on plan) including dressing of sides and ramming of bottom disposal of excavated earth, lead up to 50m and lift up to 1.5m, disposed earth to be levelled and neatly dressed. (No extra lift is payable if work is done by mechanical means) All kinds of soil. 5 SOR Item No. 4.1.2.3 :- C.C. upto plinth level: Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level: With 40mm nominal size graded stone aggregate.Nominal Mix -1 Cement : 4 sand : 8 graded stone aggregate (M -7.5) 6 SOR Item No. 6.5.2 :-Brick work with bhatta, bricks in foundation: Brick work with well brunt open bhatta, bricks, crushing strength not less than 25kg /cm2 and water absorption not more than 20% in foundation and plinth i/c curing etc complete: Cement Mortar 1:6 (1 cement: 6 sand). 7 SOR Item No. 13.2.2 :- 15 mm cement plaster: 15 mm cement plaster on the rough side of single or half brick wall of mix: 1:6 (1 cement : 6 sand) 8 SOR Item No. 10.2 :- Structural steel work built up sections: Structural steel work using M.S. flats, angles, channels I-section, H-section etc. riveted, bolted or welded in built up sections, trusses and framed work, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer all complete. 9 SOR Item No. 10.14.2 :- Steel work in built up tubular trusses/frame: Steel work in built up M.S. tubular section (round, square or rectangular hollow tubes etc.) trusses/frame work etc. including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer, including welding and bolted with special shaped washers etc. complete. Hot finished seamless type tubes. 10 SOR Item No. 12.15 :- Precoated G.I. profile sheets: Providing and fixing precoated galvanised iron profile sheets (size, shape and pitch of corrugation as approved by Engineer-in-charge) 0.50 mm + 0.05 %, total coated thickness with zinc coating 120 gsm as per IS: 277 in 240 mpa steel grade, 5-7 microns epoxy primer on both side of the sheet and polyester top coat 15-18 microns. Sheet should have protective guard film of 25 microns minimum to avoid scratches while transportation and should be supplied insingle length upto 12 metre or as desired by Engineer-in-charge. The sheet shall be fixed using self-drilling /self-tapping screws of size (5.5x 55mm) with EPDM seal, complete upto any pitch in horizontal/ vertical or curved surfaces excluding the cost of purlins, rafters and trusses and including cutting to size and shape wherever required. 11 SOR Item No. 13.64:- Synthetic enamel paint on new work: Painting with synthetic enamel paint of approved brand and manufacture to give an even shade: Two or more coats on new work. 12 SOR Item No. 11.66:- Concrete interlocking paver block:Providing and laying factory made machine pressed precast cement concrete interlocking paver block of any shape and size conforming to IS:15658- 2006 and ISI marked of 60 mm thickness, M-30 grade with grey cement and pigment all as specified. Made by block making machine with strong vibratory compaction, laid in required colour and pattern over and including 50mm thick compacted bed of stone dust, filling the joints with sand etc. all complete as per the direction of Engineer-in-Charge.

Refer document

INR 2000.0 /-

INR 1.74 Lakhs /-