|
| 1 | Earthwork excavation for foundation in all soils and sub soils in hard stiff clay, stiff black cotton, hard red earth, shales, murram, gravel, stoney earth and earth mixed with small size boulders and to full depth as may be directed,except in hard rock,requiring blasting including shoring and shuttering and bailing out of water wherever necessary,refilling the sides of foundation with excavated earth or sand in layer of not more than 15cm thick.well rammed and consolidated and depositing on bank with initial lead and lift of 10m & initial lift of 2m and depositing the surplusr earth within the compound in places shown by the departmental officers with iniital lead and lifts,clearing and levelling the site etc., complete as per SS20B and as directed by departmental Engineers(TNBP No.17,23,24). |
| 2 | PlainCement Concrete 1:4:8 mix (One Part of Cement, Four part ofFine Aggregate and Eight part of Coarse Aggregate) Using 40mm ISS HBG metal for foundation and basement including dewatering if found necessary and laid in layer of not more than 15cm thick and consolidated including all cost conveyance of materials and labour charges etc. complete as per standard specifications and as directed by departmental Engineers(TNBP No.28). |
| 3 | Filling in basement with Well Gravel well rammed watered & consolidated complying with standard specification. |
| 4 | Supplying and erecting centering for sides and soffits including supports and strutting uptp 3.29m height for plane surfaces in all floors with all cross bracings using mild steel sheets of size 90cmx60cm and 10 gauge stiffened, welded with mild steel angles of size 25mmx25x3mm for boarding laid over silver oak (country wood) joist of size 10cmx6.5cm dia spaced about 90cm centre to centre and supported by casuarina props of 10cm to 13cm dia spaced at 75cm centre tocentre etc.complete complying with standard specification and as directed by the departmental engineers. TNBP No.30 |
| 5 | A)For Beam, Lintel Roof Slab |
| 6 | B)Square column |
| 7 | C) Grade Beam |
| 8 | Reinforced Cement Concrete 1:1.5:3 mix (One cement and One and a half Fine Aggregate and Three Coarse Aggregate) Using 20mm ISS HBG metal including all cost conveyance of materials and labour charges for curing,finishing but excluding centering,shuttering and cost of reinforcement grills, including vibrating charges etc. complete as per standard specification and as directed by departmental Engineers(TNBP No.30). |
| 9 | Supplying, fabricating and placing in position mild steel or TMT rods for all reinforced cement concrete works as per design given including cost of steel and binding wire with all conveyance and lead charges in all floors etc.complete complyingwith standard specifications and as directed by the deparmental engineers.TNBP No:30 |
| 10 | Random Rubble Masonry using CM 1:5 (One part of cement & five parts of sand) mix using rough stones and bond stones for foundation and basement and including pointing above G.L including cost and conveyance of materialsto work site and including all labour charges for mixing, laying, curing the concrete etc., complete as per standard specifications and as directed by departmental Engineers.TNBP No:35H |
| 11 | Brick work in following Cement Mortar using best quality of Fly AshBrick of size 230x110x70mm for foundation and basement including curing, etc., complete complying with standard specifiction. |
| 12 | Special Ceiling Plastering with CM 1:3 (One part of cement & three parts of sand)mix for 10mm thick including cost and conveyance of materials to work site and including all labour charges for mixing, laying, curing,finishing etc., complete as per standard specifications and as directed by departmental Engineers – TNBP No:30,56&57 |
| 13 | Plastering with CM 1:5(One part of cement & five parts of sand) mix for 12mm thick including cost and conveyance of all materialsto work site and including all labour charges for mixing, laying, curing,finishing etc., complete as per standard specifications and as directed by departmental Engineers – TNBP No:56&57 |
| 14 | Weathering course concrete using best quality broken brick jelly of size 20mm uniform gauge in pure slaked lime (no sand to be used) over the RCC roof slab in the propotion of brick jelly to lime being 32:121/2 by volume and laid over in a single layer and consolidated to the required design and finished thickness , beating the concrete with wooden beaters of approved pattern, keeping the surface constantly wetted by sprinkling lime jaggery water as per standard specification,etc.complete as directed by the departmental officers.TNBP No:44-I |
| 15 | Finishing with top of roof with one course of machine pressed tiles of size 20cmx20cmx20cm of approved quality laid in cement mortar 1:3 (One cement and three sand) 12mm thick mixed with water proofing compound conforming to ISS by 2% weight of cement used and the joint pointed neatly to full depth of tiles with same water proofing compound mixed with cement motar ,red oxide, etc.complete complying with standard specification as directed by the departmental officers.- 10 m2TNBP No:44-I |
| 16 | Daddoing with first quality colour glazed tiles of 150 mm x 150 mm x 6mm size of approved make and quality and colour set in Cement Mortar 1:2 (One Cement and Two Sand) and pointing with white cement neatly including cost and conveyance of all materials etc.and all lobour charges etc.complete as per Standard specification and as directed by the departmental officers.TNBP No:special |
| 17 | Paving the floor with best quality Ceramic Tiles of size 600 x 600 x 8mm of approved colour, shade and quality laid in cement mortar 1:3 (one cement and three sand) 20mm thick in all floors and the top pointed with the white cement mixed same colour pigments etc., complete complying with standard specification. |
| 18 | Supplying and fixing M.S Grill to doors, special windows and ventilators etc using 20mmx6mm as directed by the departmental officers inclusive of cost of MS grill including one primer coat of red oxide and fixing in position etc. including cost and conveyance of all materials and all lobour charges etc.complete as per Standard specification and as directed by the departmental officers.(as per the schedule of rate)TNBP No:86 & 86-A |
| 19 | Painting the new walls two coats over one coat of priming with best weather proof Exterior Emulsion paint of approved colour and quality including preparation of surface and finishing neatly etc., complete complying with standard specification and as directed by departmental officersComplete as per standard specification. |
| 20 | Painting with two coats of Approvedcolour of best quality synthetic enamel paint, painting over new iron work including cost and conveyance of all materials and all labour charges etc. complete as per Standard specification and as directed by the departmental officers. (New Iron Surface).TNBP No:66&66-A |
| 21 | Wiring with 2x1.5sqmm (22 / 0.3) PVC insulated SC unsheathed Cu. Conductor of 1100v grade in suitable PVC rigid pipe concealed in wall and ceiling with PVC accessories in flush with wall with 3mm thick hylum sheet cover with TW switch box and 5A F.T switch and making good of the concealed portion with suitable colour for PVC concealed light point. SD 24 ISI make with standard specification. |
| 22 | Wiring with 2x1.5sqmm (22 / 0.3) PVC insulated SC unscheathed Cu.conductor of 1100 V grade in suitable PVC rigid pipe concealed in wall and ceiling with PVC accessories, in flush with wall, with 150mm x 100mm x 113mm TW switch box with 3mm thick Hylem sheet cover for 5 A 3 pin non inter locking CS Plug with continuous earth wire connection of 14 SWG TC wire and making good of the concealed portion with suitable colour for concealed PVC plug point. SD 38ISI make with standard specification |
| 23 | Supply and run of 4 of 4 sq.mm. (56 / 0.3) PVC insulated single core unsheathed copper conductor of 1100V gradeon 7 / 20 GI bearer wire for service connection mainsSD 67ISI make with standard specification. |
| 24 | Supply and run of 4 of 4 sq.mm. (56/0.3) PVC insulated single core unsheathed copper conductor of 1100V grade in 25mm dia GI pipe (Class \"B\") bent at both ends with necessary angle iron up right and end supports for mains. SD 72 ISI make with standard specification. |
| 25 | Supply and fixing of 32 Amps DPIC switch of 500V with metal clad with fuse and netural TW Board with earth connection only. SD 143 ISI make with standard specification. |
| 26 | Supplying and fixing of white vitreous Wash basin of approved make. |
| 27 | Supply and fixing Indian Type water closet including cost and conveyance charges to site etc complete. ISI make with standard specification. |
| 28 | Supplying and fixing in position of glazed water closet of size 58 cm with ‘P’ trap; and double flopped seat cover, 12.5 litres capacity PVC low level automatic flushing tank including all internal plated brown headed stopcock, 12 mm nylon connection with necessary teak wood plugs, clamps screws to the portion of coming with wall or floors, including dismantling masonry and redoing the same to the original condition. |
| 29 | Solid PVC door shutters using 19 gauge 19 mm MS square tubes for styles and outer frames. 15 mm MS square tubes for top lock and bottom rails. The steel tubes shall be covered with 5 mm thick solid PVC sheets. Shutter using 5 mm thick solid PVC sheets for paneling shall rigidly fixed in position including necessary furniture and fittings. |
| 30 | Supplying and fixing Teak Wood scantling wrought and putup for frames of doors, windows and ventilators including fixing hold fast and all labour charges cost and conveyance of all materials to site and all albour charges etc complete as per standard specification. |
| 31 | Supply and fixing of 1.20 x 2.10 m size (2 equal pannels) fully pannelled door including cost of scantlings, internal moulded planks, iron hold fasts, tower bolts, aldrops and labour at rought and put up in position for frames and shutters incuding all labour charges etc complete as per standard specification. |
| 32 | Supplying and fixing of country wood wrought and put up in scantling over 4 m length for fixing in position of rafter and roof timbers including cost and conveyance of all materials labour charges etc. complete. |
| 33 | Supplying and fixing of wrought and put up country wood shutters for fully paneled (five equal panel) single leaf door with provision shall be made for 3 numbers of hinges, tower bolt 2 numbers Aldrop 1 number handle 1 number lock with key 1 set and 50 mm Ø rubber block. |
| 34 | Supply and fixing of 18W 4 feet LED light fitting (M-1274) |
| 35 | Supply and delivery of fixing of HDPE tank 1000 litres capacity as per IS 12701/1996 including loading, unloading, transportation and labour charges for fixing of GI pipes and specials for pipe connection works including cutting, threading and fixing chargers as directed by officers. |
