|
| 1 | Labour for chipping of concrete surface before taking up plastering work |
| 2 | Ordinary cement concrete(mix 1:2:4) with graded stone chips (20 mm nominal size) excluding shuttring and reinforcement, if any, in ground floor as per relevant IS codes. (b) River bazree. |
| 3 | Plaster ( to wall, floor, ceiling etc.) with sand and cement mortar including rounding off or chamfering conrners as directed and raking out joints including throating, nosing and drip course, scaffolding/staging where necessary (ground floor). [Excluding cost of chipping over concrete surface].(i) with 1:4 cement mortar. (b) 20 mm. thickplaster. |
| 4 | Wood work in door and window frame fitted and fixed in position complete including a protective coat of painting at the contact surface of the frame excluding cost of concrete, Iron Butt Hinges and M.S clamps. (The quantum should be corrected up to three decimals). |
| 5 | Panel shutters of door and window, as per design (each panel consisting of single plank with out joint), including fitting and fixing the same in position but excluding the cost of hinge and other fittings.In ground floor.(In case of non-supply of single plank, panel rate of reduction of 20% will be made). |
| 6 | Iron butt hinges of approved qualityfitted and fixed with steel screws, with ISI mark. |
| 7 | Anodise aluminium barred/tower/socket bolt (full covered) of approved manufactured from extruded section conforming to I.S.204/74 fitted and Fixed with cadmium plated screws:.. |
| 8 | Iron pad bolt (lock) of approved quality rod and handle single cast. |
| 9 | Galvanized corrugated iron sheet work (excluding the supporting frame work) fitted and fixed with 10 mm. dia J or L hook-bolts, limpet and bitumen washers and putty complete with 150 mm. end lap and one corrugaion minimum side lap. ( payment to be made on area of finished work). (GCI sheet to be supplied by contractor). . |
| 10 | Galvanized corrugated iron sheet ridging fitted with necessary bolt, screws,washers,etc. complete. (225mm end lapping). |
| 11 | Galvanized corrugated iron sheet ridging fitted with necessary bolt, screws,washers,etc. complete. (225mm end lapping).Wide gutter. |
| 12 | Prime one coat on timber of plastered surface withsynthetic enamel oil bound primer of approved quality including smoothing surfaces by sand papering etc. |
| 13 | (A) Painting with best quality synthetic enamel paint of approved make and brand including smoothening surface by sandparpering etc. in cluding using of approved putty etc. on the surface , if necessary. |
| 14 | Add 18 % GST on Total Amount |
| 15 | Add 1%labour cess on (Total Amount + GST) |
| 16 | AddContigency |
