Providing And Fitting Of Components To 150 Kva Manually Operated Voltage Stabilizer Installed At Tubewell New Nanak Nagar Under Non Plan- 1 Providing And Fitting Of Components To 150 Kvavoltage Stabilizer Oftubewell New Nanak Nagar By Way Of Disconnectin, jammu-Jammu And Kashmir

Providing And Fitting Of Components To 150 Kva Manually Operated Voltage Stabilizer Installed At Tubewell New Nanak Nagar Under Non Plan- 1 Providing And Fitting Of Components To 150 Kvavoltage Stabilizer Oftubewell New Nanak Nagar By Way Of Disconnecting Input And Output Electric Supply Connections Of The Voltage Stabilizer And Making Connections Of Main Switch Directly With The Lt Control Panel. Dragging The Voltage Stabilizer From Its Position To Outside The Pump Room With The Help Of Crane, Manual Labour And Allied Tools And Tackles. Dismantling Of Top Cover And Extraction Of The Transformer Assembly From The Oil Tank With The Help Of Chain Pulley Block. Complete Replacement Ofthree No. Main Coil By Providing And Fitting Of New Coils Made Out Of Superior Quality Copper Wire As Per The Original Design And Varnishing Of All The Coil Sets. Dismantling And Extraction Of Rotary Switch Assemblies, Providing And Fitting Of 3 No. Rotary Switch Assemblies. The Job Further Involves Draining Out All The Transformer Oil From The Oil Tank, Cleaning The Oil Tank, Dehydrating The Transformer-Oil By Heating With The Heating Coils. Again Refilling The Same T- Oil After Dehydration, Filtration And Adding Fresh T-Oil 90 Litres To Top Up The Level. Assembling The Stabilizer Transformer And Lowering In The Oil Tank With The Help Of Chain Pulley Block. Fitting The Panel Board And Top Cover, Making Connections After Replacing Electronic Meters And Led Indicators And Testing On Full Load. Complete Job Includes The Cost Of Material And Labour Charges. 2 Upkeepment Of 6000 Gph X 80 Mtrx 12.5 Hp Submersible Pumpset Of T / Well Sec-14 Nanak Nagar By Way Of Disconnection Of Power Supply And Extraction Of Submersible Pumpset Using Skilled Labour With Allied Tools And Tackles. Dismantling And Shifting Of Pumpset To Workshop By Mech. Transport. Repairing By Providing, Fabrication And Fitting Of S.S Pump Shaft As Per Sample, 8No. Impellers, 6 No. Pump Bodies, 8No. Neck Rings, 8No. Body Bushes, Ss Coupling Pulley And Nut Bolts And Assembling Of Punp Atworkshop. The Job Includes Dismantling And Repairing Of 12.5 Hp Submersible Motor By Providing, Fabrication And Fitting Of Thrust Pad Set And Rotor Bushes. Assembling Of The Motor, Coupling With Pump And Testing The Pumpset In The Test Pit Then Shifting Of Pumpset To The Site Of Installation. Making Electrical Connections Of Motor With Sub Cable By Making Leak Proof Joint And Lowering Of Pump Set Along With Providing And Replacing Rubber Gaskets And Nut Bolts. Making Connections Of Submersible Cable With Panel And Then Testing On Full Load

INR 200 /-

Refer document

INR 95500.0 /-