|
| 1 | RFID Module | Voltage 5.0V (+3.7V~+5.5V),Current=1.0A / 5V,840~960MHz at option; Fixed or FHSS |
| 2 | GSM | Supply voltage range 3.4 ~ 4.4V,Quad-band 850/900/1800/1900MHz,Point to point MO and MT•SMS cell broadcast•Text and PDU mode |
| 3 | Dust Sensor | Volt 12-24VDC,Op Voltage 4-20mA,0-5V,0-10V,RS485,response time <90s |
| 4 | USB Cable | 2.4A fast charge,length,USB 3.0 Connecto0.5m/1m/2m |
| 5 | DTH1 | Volatge 3 V - 5.5 V,Size 28.2 mm (length) * 13.1 mm (width) * 10 mm (high) |
| 6 | Servo Motor | 80mm 750w 220V 3000rpm single-Phase |
| 7 | 12V, 1.3AH Batt. | DC battery ,nominal vol-120V, Cap 1.3AH |
| 8 | HCSR04 | ut:5V High,Current,Range 4cm~450cm 5mA |
| 9 | Chasis | Size max 20mm |
| 10 | 100RPM Motor | Voltage range: 3-12V,Continous current 0.17A, Torque,DC0.3-3.0Kg.cm |
| 11 | TILT Sensor | Vol:5V,Tilt Angle 30° ±15° |
| 12 | LM35 | Operates From 4 V to 30 V • Less Than 60-µA Current Drain,Rated for Full -55°C to 150°C Range |
| 13 | Soil Sensor | Humi. ±3% Temp. ±0.5?,Temp-20?~+60?, output signa 0%RH~80%RH4~20mA/0~5V/0~10V/RS485 |
| 14 | IR Module | Operating voltage range: DC 4.5-20V,Current: <50uA,Angle Sensor: <100 ° cone angle,Operation Temp: -15-+70 degrees |
| 15 | Rain Sensor | Analog output :0-5V,Operating current: <3mA,Response time: <100ms,0-60°C |
| 16 | Gas Sensor | Current Sensor,Pore size:0.2-120um,Accuracy:99%,Gas type:CH4, LPG, hydrogen, combustible gas |
| 17 | PIR Sensor | Operating voltage range: DC 4.5-20V,Current: <50uA,Angle Sensor: <100 ° cone angle,Operation Temp: -15-+70 degrees |
| 18 | Hall Effect | Load Reisirtance =10,suppl vol +12(±5%)V,Accuracy =1 .0 ( T=25?VC=±15V) |
| 19 | 5V / 2CH Relay | 2-channel photocoupler ,Vol:Supply voltage: 5VDC, 12VDC,Current: greater than 100mALoad: 250V 10A AC or 30V 10A DC |
| 20 | 5V / 1CH Relay | Voltage version : 5V,Quiescent current: 4mAWorking current: 65mATrigger voltage: 0-2VTrigger current: 2mA |
| 21 | CC2500 Zigbee | working frequency 2400~2450MHz,transmission distance up to 3300Bps, |
| 22 | GPS Module | Transmitting power 20dBm,working current 2.8V 3. 5W less than 50mA,Receive sensitivity 1-97 dBm |
| 23 | L293D Module | Motor Power (VM): 4.5V ~ 36V,Operating current Iss: =60mA (Vi = L), =22mA (Vi = H);Working temperature: -25~ + 125 |
| 24 | HC05 Blue Tooth Module | Transmit power:+4dBm(-20 dBm to +4 dBm),Receiver sensitivity:-96 dBm,1.7 to 3.6V |
| 25 | Dummy Wheel | Tyre Dia:252mm,Tyre width:44mm,Bore dia:12.7mm |
| 26 | Chasis forRobo | Metal chassis for robot,Wieght <200gm |
| 27 | Motor Wheel | Operating voltage: 3.5V - 8V,No load current: 40mA@6V (approx) Static current: < 1mA (no control signal input),Easily implement forward/reverse control and speed control DC Volts. |
| 28 | LDR Big | Maximum Voltage: 150 Volt DC,Maximum Wattage: 90mW,light Resistance (10 Lux): 5-10 Kohm,Operating Temperature: -30 ~ +70 deg C |
| 29 | Toy DC Motor | 5V load (r / min): 208V,Wheel diameter: 65MM * 27MM,Torque: 0.8KG.CM,DC: 3-7.2V |
| 30 | Arduino Uno | Microcontroller atmega328p,Operating voltage : 5v digital I/o pins,Digital I/o pins .6 analog input pins, 6 flash memory 32 kb (atmega328p) of which 0.5 kb used by bootloader,uno r3 atmega328p with usb cable length |
| 31 | ESP8266 | 10 gpio, every gpio can be pwm,Pcb antenna,I2c, 1-wire, plug & play,weight: 60 gms |
| 32 | Solar Panel | 5W Solar Panel 8.8V, O.57A |
| 33 | Buck & Boost converter | 5.5-30V 12v to DC 0.5-30V |
| 34 | Solar Radiation module (UV) | Response spectrum: 200nm-370nm,Dimension: 22.0mm * 16.0mm,Mounting holes size: 2.0mm |
| 35 | PM2.5 & PM 10 Sensor | Power supply voltage: DC5 ± 2V,Sensitivity: 0.5V / (0.1mg / m3),Clean air voltage: 0.9V typ. |
| 36 | PH Sensor | Size: 30 x 3.99 x 3.99 cm,118 g |
