|
| 1 | Design, Engineering, Manufacturing, Fabrication, Assembly, Testing, Inspection by TPI,packing and Supply of Centrifugal Pump with non-flameproof motor including supply of all commissioning spares & 2 years mandatory spares, supervision during installation & commissioning for Sulphuric acid unloading pump at ETP at IOCL Guwahati Refinery |
| 2 | Supply of pump with non-flameproof motor on common base frame, coupling & coupling guard, Anchor bolts, with 1 set of companion flanges, gasket, bolts and nuts, suction strainer, foundation bolts. |
| 3 | Set of impeller (Full dia) |
| 4 | Impeller nut |
| 5 | Shaft |
| 6 | Shaft Key – coupling end |
| 7 | Shaft key- impeller end |
| 8 | Shaft key – any other fitted on the shaft(Note: If more than 1 part no is applicable, bidder to provide break up cost of each item) |
| 9 | Set of shaft sleeves |
| 10 | Set of case wear rings |
| 11 | Set of impeller wear rings |
| 12 | Set of throat bushing |
| 13 | Set of throttle bushing |
| 14 | Set of Pump body gaskets / o-rings |
| 15 | Set of Pump brg cover gaskets/ o-rings |
| 16 | Set of gasket / o-rings /seals–any other fitted on pump (Note: If more than 1 part no is applicable, bidder to provide break up cost of each item) |
| 17 | Set of oil seals as applicable |
| 18 | Set of constant level oilers |
| 19 | Set of deflectors/ bearing isolators |
| 20 | Set of mechanical Seal (Complete assembly) With sleeve and gland plate |
| 21 | Set of mechanical Seal parts:a. Seal Faces (stationary)(For bellow type, set shall mean face along with bellows) |
| 22 | Set of mechanical Seal parts:b. Seal Faces (Rotary)(For bellow type, set shall mean face along with bellows) |
| 23 | Set of mechanical Seal parts:c. Secondary Seal as applicable |
| 24 | Set of mechanical Seal parts:d. Gaskets/O-rings & Packings |
| 25 | Set of mechanical Seal parts:e. Spring and Pins, Screws |
| 26 | Complete coupling (balanced) |
| 27 | Set of Balance drum and balance sleeve insert (if provided) |
| 28 | Set of bearings with bearing pads – DE side |
| 29 | Set of bearings with bearing pads – NDE side |
| 30 | Flushing oil cooler (in case of plan-23) |
| 31 | Any other spares as per offered pump’s requirement |
| 32 | Set of motor bearing |
| 33 | NDE side end Shield |
| 34 | DE side End shield |
| 35 | Cooling Fans |
| 36 | Cooling fan cover |
| 37 | Terminal box with studs, insulators & connectors |
| 38 | Grease cup |
| 39 | Complete set of instrument spares as applicable |
| 40 | Per diem site supervision charges |
