||Structural steel work riveted, bolted or welded in built up sections, trusses and framed work, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer all complete.
||Structural steel work in single section, fixed with or without connecting plate, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer all complete.
||Brick work with common burnt clay F.P.S. (non modular) bricks of class designation 7.5 in superstructure above plinth level up to floor V level in all shapes and sizes in:Cement mortar 1:4 ( 1 cement : 4 coarse sand)
||12 mm cement plaster of mix 1:4 (1cement : 4 fine sand)
||Applying priming coats with primer of approved brand and manufacture, having low VOC (Volatile\nOrganic Compound) content.With water thinnable cement primer on walls surface having VOC content less than 50 grams / litre
||Wall painting with plastic emulsion paint of approved brand and manufacture to give an even shade:One or more coats on old work
||Steel work in built up G I tubular ( round, square or rectangular hollow tubes etc.) trusses etc., including cutting, hoisting,fixing in position and applying a priming coat of approved steel primer, including welding and bolted with special shaped washers etc. complete
||Providing & fixing polycarbonate corrugated sheet 0.8 mm thick as approved by the engineer in charge and should be supplied in a single length of 12 m or as decide by the engineer in charge. The sheets shall be fixed using selfdrilling/self tapping screw of size(5.5/55mm) with EPDM seal complete upto any pitch in horizontal/Vertical / Curved surface,but excluding the cost of purlins, rafters, trusses, and including cutting to size shapes wherever required
||0.35mm thick GI powder coated trafford sheet with GI hooks, crank bolts & nuts including bitumen washers, etc. complete.
||Hips of with 40cm overall width, plain GI powder coated sheet with hooks, bolts, nuts, bitumen washers, etc. complete.
||Fixing PVC split pipe including jointing of pipe with one step PVC solvent cement, testing of joints, complete as per direction of Engineer-in-charge. 200mm 4kgf/sq cm.