annual plan-tpba bp project no. 94/2025-26-vellad pakal veedu repair in naduvil gp-general civil work -maintenance works 14.5.1:renewing glass panes, with putty and nails wherever necessary including racking out the old putty :float glass panes of thickness 4 mm (weight not less than 10kg/sqm) 14.8.2:supplying and fixing new wooden fillets wherever necessary :hollock wood fillets 50.9.1.1:providing wood work in frames of doors, windows, clerestory windows and other frames, wrought framed and fixed in position with hold fast lugs or with dash fasteners of required dia & length (hold fast lugs or dash fastener shall be paid for separately), using good quality anjili wood /jack wood 14.85:taking out existing wooden door shutter, repair by cutting, painting etc. and refixing of repaired door shutters to existing door frames, including replacement of hinges with screws, etc. as required, all complete as per the direction of the engineer-in-charge. 13.88:removing white or colour wash by scrapping and sand papering and preparing the surface smooth including necessary repairs to scratches etc. complete. 13.98.1:wall painting with plastic emulsion paint of approved brand and manufacture to give an even shade:one or more coats on old work 13.99.1:painting with synthetic enamel paint of approved brand and manufacture of required colour to give an even shade :one or more coats on old work 50.10.2:steel work for purlin/single section with g i pipes including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer, including welding and bolted with special shaped washers etc. complete 10.20:providing and fixing bolts including nuts and washers complete. 13.61.1:painting with synthetic enamel paint of approved brand and manufacture to give an even shade:two or more coats on new work od329190/2025-2026:providing and fixing alu-zinc profile sheets (size, shape and pitch of corrugation as approved by engineer-in-charge) 0.40mm (+0.05%) thickness. sheet should have protective guard film of 25microns minimum to avoid scratches during transportation and should be supplied in single length up to 12metre or as desired by engineer-in-charge. the sheet shall be fixed using self drilling/self tapping screws of size(5.5x55mm)with epdm seal, complete up to any pitch in horizontal/vertical or curved surfaces, excluding the cost of purlins, rafter sand trusses and including cutting to size and shape wherever required. (mod 12.50 of dsr ) 50.18.7.3.2:providing and fixing pvc pipes, fittings including fixing the pipe with clamps at 1.00 m spacing. this includes jointing of pipes & fittings with one step pvc solvent cement and testing of joints complete as per direction of engineer-in-charge 25 mm dia 10kgf/ cm2- internal work- exposed on wall 18.15.2:providing and fixing brass bib cock of approved quality :20 mm nominal bore