e tender for supply of outdoor gym ist call - 1 outdoor gym 2 leg press 3 arm and shoulder wheel 4 double cross walker 5 pull chair 6 elliptical exerciser 7 air swing 8 air walker: 9 horse rider station 10 sit up station 11 exercising bar 12 seated chest press 13 chin up bar 14 stair stepper 15 arm wheel 16 rowing machine 17 knee hip raise 18 twister 19 base work:- 20 supplying and filling in plinth with crusher stone dust / coarse sand under floors including, watering, ramming consolidating in layers not exceeding 20cm in depth in layers not exceeding 20cm in depth and dressing complete. ( sor i / 2.26 p / 7 ) 21 earth work in excavation by mechanical means ( hydraulic excavator ) / manual means over areas ( exceeding 30cm in depth. 1.5m in width as well as 10 sqm on plan ) including dressing of sides and ramming of bottom disposal of excavated earth, lead upto 50m and lift upto 1.5m, disposed earth to be levelled and neatly dressed. ( no extra lift is payable if work is done by mechanical means ) nall kinds of soil n 22 providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - all work up to plinth level: nwith 20mm nominal size graded stone aggregate. nm 15 – grade concrete n4.1.1.3 n 23 brick work with fly ash lime bricks ( falg bricks ) conforming to is:12894-2002, in super structure above plinth level up to floor ii level in : ncement mortar 1:6 ( 1 cement : 6 sand ) 6.6.2 n 24 providing and laying at or near ground level factory made kerb stone of m-25 grade cement concrete in position to the required line, level and curvature, jointed with cement mortar 1:3 ( 1 cement: 3 sand ) , including making joints with or without grooves ( thickness of joints except at sharp curve shall not to more than 5mm ) , including making drainage opening wherever required complete etc. as per direction of engineer-in-charge ( length of finished kerb edging shall be measured for payment ) . ( precast c.c. kerb stone shall be approved by engineer-in-charge ) .sor 11.84 25 providing and laying factory made coloured chamfered edge cement concrete paver blocks of required strength, thickness and size / shape, made by table vibratory method using pu mould, laid in required colour and pattern over 50mm thick compacted bed of stone dust, compacting and proper embedding / laying of inter locking paver blocks into the bedding layer through vibratory compaction by using plate vibrator, filling the joints with sand and cutting of paver blocks as per required size and pattern, finishing and sweeping extra sand including locking edges with m 15 cement concrete in footpath, parks, lawns, drive ways or light traffic parking etc. complete as per manufacturers specifications and direction of engineerin- charge. 80mm thick c.c. paver block of m-35 grade with approved colour, design and pattern.sor 11.83