tender for damaged divider and side parting work on both sides in front of lucknow university new campus under jankipuram expansion plan. - clearing jungle including uprooting of rank vegetation, grass, brush wood, trees and saplings of girth up to 30 cm measured at a height of 1 m above ground level and removal of rubbish up to a distance of 50 m outside the periphery of the area cleared. (dsr-2023/2.31) 2 earthworkinsurfaceexcavationnotexceeding30 cm in depth but exceeding 1.5m in width as well as 10 sq.m. on plan including getting out and disposal of excavated earth upto 50m and lift upto 1.5m, as directed by engineer-in-charge: all kind od soil. (dsr-2023/2.1.1) 3 providing and laying in position cement concrete of specifiedgrade excluding the cost of centering and shuttering - all workup to plinth level. 1:4:8 ( 1 cement : 4 coarse sand {zone-iii} : 8 graded stone aggregate 40mm nominal size)(dsr-2023/4.1.8) 4 class-150 (non modular) brick work in 1:4 (1 part cement : 4 part coarse sand) in foundation and plinth including supply of all materials, labour and t&p etc. required for proper completion of the work.(dsr-2023/6.1.1) 5 providing and laying in 1:2:4 (1 part cement : 2 part coarse sand : 4 part 20 mm gauge stone grit) position cement concrete of specifiedgrade excluding the cost of centering and shuttering - all workup to plinth level. (dsr-2023/4.1.3) 6 12 mmthick cement plasterin single coat onside of single brick wall for interior & outer plaster upto floor two level including internal rounded angles chamfers and rounded angles not exceeding 80mm in girth and finishes even and smooth. (1cement:4 fine sand) (dsr-2023/13.4.1) 7 construction of granular sub-base by providing well graded material, spreading in uniform layers with motor grader on prepared surface, mixing by mix in place method with rotavator at omc, and compacting with smooth wheel roller to achieve the desired density, complete as per technical specification clause-401 (sanction rate) 8 providing and laying factory made chamfered edge cement concrete paver blocks in footpath, parks, lawns, drive ways or light traffic parking etc, of required strength, thickness & size/ shape, made by table vibratory method using pu mould, laid in required colour & pattern over 50 mm thick compacted bed of sand, compacting and proper embedding/laying of inter locking paver blocks into the sand bedding layer through vibratory compaction by using plate vibrator, filling the joints with sand and cutting of paver blocks as per required size and pattern, finishing and sweeping extra sand. complete all as per direction of engineer-in-charge 80 mm thick c.c. paver block of m-35 grade with approved colour design and pattern.(dsr-2023/16.91.2) 9 providing and applying white cement based putty of average thickness 1 mm, of approved brand and manufacturer, over the plastered wall surface to prepare the surface even and smooth complete. (dsr-2023/13.80) 10 finishing walls with premium acrylic smooth exterior paint with silicone additives of required shadeold work (two or more coats applied @ 1.43 ltr/ 10 sqm) over existing cement paint surface (dsr no. 13.112.1/2023)