biennial rate contract for the supply of spares of m/s l and t mhi power boilers pvt ltd make coal mill(mvm32f) installed at boiler area of 2x660mw,stage-ii sstpp,mppgcl,dongalia , lower - housing , fitting plate for air seal assembly (mark no. 4 dwg no. c-10-32r-5788) ( 1set = 1 mill qty.) , complete hub skirt assembly , middle housing , grinding table upper ring(thk 20 mm) , deflector assembly (dwg no.10-32r-6724 r1) , complete deflector assembly duly installed tiles without liners with bolt, nut m16x40 spot weldedfor top liners and bottom hard chrome liners , taper cup (part no.n67-700-1181-1 , mark no. 08) , ceramic liner cover (part no.n67-700-1181-3 , mark no. 09) , washer (part no.n67-700-1175-1 , mark no. 32) , ceramic liner cover (part no.n67-700-1174-2 , mark no. 31) , ceramic liner (part no.n67-700-1174-1 , mark no. 30) , set screw (part no.170-255-020-2 , mark no. 103) , bolt(part no.n67-700-1173-2 , mark no. 28) with nut (m16) ( 1 set = 1/3 mill qty) , complete set of tiles for deflector with weldable/taper plug and ceramic cap ( 1 set = 1/3 mill qty.) , rj cover (dwg no. c-10-32f-61306) , journal gap bolt bushing (dwg. mark no 2) , piston housing (dwg mark no 3) , bushing retainer (dwg mark no 4) , lock plate (dwg mark no 8) , lock plate (dwg mark no 9) , lock plate (dwg mark no 10) , roller lift gauge (dwg. mark no 14) , roller lift gauge fitting plate(dwg. mark no 15) , shim(piston bush) (dwg. mark no18) ( 1 set = 1/3 mill qty) , dust seal for roller tensioning system (mark no 13) 1 set = 1/3 mill qty.) , classifier , complete set oftiles for center cone and center feed pipe with weldable plug and ceramic cap ( 1 set = 1 mill qty) , outlet ring ( classifier) moc hardox: 400 (suitably in 3-4 segments) , slide outlet (classifier) moc hardox 400 (suitably in 3-4 segments) , complete outlet ring drive assembly , centre cone support pipe with flange duly installed tiles.( 3 nos = 1 mill qty.) , center feed pipe outlet ( classifier) , end cup (thrust) , end cup ( free) , end cup bush locking set screw (mhi dwg no n67-700-6177) (1 set = 1 mill qty) , r j assembly , seal kit complete set for rja ( 1 set = 1 rja) , upper plate , stop plate , journal head