repairs to drr- 455 wilson- 1 repair to drr by way of dismantling of clutch system and removing of old damaged parts and then p/f of plate driving (306-3-1) -02 no., collar assembly (306-3-7)- 02 nos., sleeve sliding (306-3-9)-02nos, pin lock adjusting(306-3-11)-02 no., pin link lever (306-3-13)-12 nos., lever (306-3-4)-06 nos., pin for lever ( 306-3-5)-06 nos., link lever(306-3-6)-12 nos., cotter pin (sp-7-009)-06 nos., grease nipple (gn-8-001)-01 nos, cover (306-4-3) 02 nos., ball bearing (306-4-29) 01 no, ball bearing (306-4-27) 02 nos., locking wire (306-4-11) 02 nos. testing of clutch system after assembling of all these parts. the job further includes repair to alternator with replacement of armature, bearings, carbon brushes and retapping to field coil. job also includesgreasing of front roll, rear rolls, drive pinions with 10 kgs grease and topping of gear oil with 05 litres for completing the gauge. complete job includes the cost of parts, labour and other tools and tackles required for job with all taxes. 2 repair to operator seat with electrical/gas welding and then p/f of cushioning material to seat and backrest with cover along with angle frame and plywood.complete job includes cost of material and labour charges (skilled and unskilled) including of all taxes. the job further includes providing and fitting of fuel pipe from tank to lift pump-01 no., fuel pipe from feed pump to filter-01 no., fuel pipe from filter to f.i.p-01 no, hose pipe – 01 set, cable battery to starter (309-5-42) 01 no, cable battery to earth(309-5-43) 01 no, oil seal 01 no, accelerator cable – 01 no, starter switch- 01 no. complete job includes the cost of parts, labour and other tools and tackles required for job with all taxes. 3 rebate on account of old parts (absolute)