repair of damaged poles, dilapidated lines and other maintenance work in areas coming under sub-division bharthana under electricity distribution division ii, etawah.- 1 safe carriage ofstp / pcc pole from store center etawah to site of work. including loading & unloading at both ends. 2 safe carriage ofline materialfrom store center etawah to site of work. including loading & unloading at both ends. 3 erection and grouting ofstp / pcc pole duly grouted including necessories clamps, accessories required fixing of ht / lt fittings as per respo norms. the support shall be grouted in cement, sand and brick ballast. it including the cost of all labour, t&p etc. required for proper completion of work. 4 erection and grouting of double pole structure of 9 / 8.5 mtrs longpcc pole duly grouted including necessories clamps, accessories required fixing of ht / lt fittings as per respo norms. the support shall be grouted in cement, sand and brick ballast. it including the cost of all labour, t&p etc. required for proper completion of work. 5 installation of stay set with grouting and nuzzling etc. as per respo drawing / norms along with all routine material to be used for such works. 6 earthing of poles by fixing earthing rods and binding with earth wire as per standard norms including cost of labour t&p and required material for such work. 7 dismantling & re-installation of consumer’s cable service connection from existing line feeding consumer supply. 8 laying, sagging and stringing and jumpering / binding etc. ofarial bunch conductor 3x50 sq mm. in lt lines as per respo manual and as per direction of executive engineer including the cost of arrangement of labour, t&p, carrier etc. required for proper completion of work 9 laying, sagging and stringing and jumpering / binding etc. ofacsr weasel / raccon conductor in 11 kv / lt lines as per respo manual and as per direction of executive engineer including the cost of arrangement of labour, t&p, carrier etc. required for proper completion of work 10 dismantlingof existing old conductor, from the various areain the respective j.e.’s ( store ) as per direction of supervising engineer. it includes the work of cartage the cost of labour t & p carrier etc. required for proper completion of work. 11 re-sagging of loose 11 kv. / l.t. line as per direction of executive engineer. it includes the cost of labour, t&p etc required for proper completion of work. 12 re-nuzzling of old stay set by opening old binding for better straightening of pole and re-sag the existing conductor of h.t / l.t line properly as per direction of supervising engineer. 13 straightening of 8.5 / 9 mtr. long pcc / st / rail pole tilted poleat various places by straighteningof pole including the cost of labour , t&p charges required for proper completion of work. 14 chopping of tree branches to clear the line route to give horizontal and vertical clearance to the line including cost of labour t&p etc. 15 repairing / resagging / new guardingof ht / lt line with gi wire as per respo norms. 16 replacement of following broken / damaged / missing accessories by new accessories including opening of the same and refixing. ( i ) 11 kv line jumper 17 ( ii ) lt line jumper 18 ( iii ) 11 kv pin insulator 19 ( iv ) 33 kv disc insulator 20 ( v ) cross arms holding clamps 21 ( vii ) stays clamp 22 carriage of scrap material ( 11 / 13 mtrs. long damaged st pole from pit site to j.e store kunera etawah including the cost of arrangement of labour, t&p, carrier etc. required for proper completion of work.