regarding supply and commissioning of automatic power factor panel. . , regarding supply and commissioning of automatic power factor panel , regarding supply and commissioning of automatic power factor panel (l& t make). automatic power factor control panel board commissioning the following equipments and details etc (without capacter) rating of the panel 1500 kvr. 1.main incoming acb/3200 amp. (l& t make) 3 pole 2. mdo complete with on off indicator/pfc relay of 12 way with mcb and lockabel hrc fuse kit kat 3. outgoing feedrs mccb 800 amp 12 nos 4. air breaker contactors with ml 12 (l& t make) 12 nos. 5. coil operation voltage 220 volt. 6. incoming supply indicator ryb 7. on off indicator reb/green 8. digital ameper meter showing 3 phase load and volt meter with cts, selecter switch for volt meter. digital ampere with all feders with cities 9. on off indicators for all feders 10. all material is of (l& t make). 11 all mccb is of same model and category. 12 cable entry from bottom side. 13 aluminium bus bar tpn with heat shrinkable relays. 14 ms enclose 14 gauges cold rod sheet steel with seimens gray color coated paints. 15 all supporting channels of also 14gauges 16 paneel supported with ms bus bars 17 the panel shall be totally enclosed floor mounted type, dust and werming proof. louvers shall be provided in the panel for air circulations 18 the panel shall designed for an ambint temp. of 50 degree c, and the maximum temperature of the bus bar shall not be exceed of 85 degree c. 19 the operating height of the panel shall be 2000 mm , the panel door compartment shall be interlocked in such a way that it shall not be possible to open them when is closed/on position. the bus bar will be provided in the panel shall be of aluminium ec/91 e grade.the size of the neutal bus bar shall be half of that of phase bus bar the earth nus bar shall be located at the bottomand shall be continous thourhg the length of the panel. the removale sheet steel gland plates shall be provided at the bottom of the panels cables entery.