work of cutting welding threading under jen section kishangarh renwal rural under sub division kishangarh renwal (arc)executive engineerphed, dn- 1 turning o fvarious sizes of cid joints class-10/15 completeset(labour charges),thejointswillbe suppliedby the junior engineerconcernof department and carting to workshop and after turning of these joints, firm is liable to transport upto junior engineer concernsstore own his cost. 2 80 mm dia 3 100 mm dia 4 125 mm dia 5 150 mm dia 6 200 mm dia 7 250 mm dia 8 thre adingon gi pipes different diameter as below (rate per mouththre ading). the pipes will be suppliedby the department and carting to work shop and after thre ading of the sepipes ,firmis liable to transport upto junior engineer concerns store own his cost. 9 32mm 10 50mm 11 65mm 12 80 mm 13 101 mm 14 125mm 15 150mm 16 welding on m.s. / g.i./ci pipes and other material by electric welding, this includesall the materiallike welding rods/equi pmentlike welding machine/generater, if required for job. 17 at work shop 18 on site 19 supplying of ms rods for different sizes of sluice valveand should be supplied as according to size of old rodsincluding material and finishing for the following sizes. 20 sluice valve size 80mm 21 sluice valve size 100mm 22 sluice valve size125mm 23 sluice valve size 150mm 24 supply in gofchuck nut for differen tsizes of sluice valveand should be supplied as according to size of check nut including material for the following sizes. 25 sluice valve size 80mm 26 sluice valve size 100mm 27 sluice valve size 125mm 28 sluice valve size 150mm 29 sluice valve size 200mm 30 sluice valve size 250mm 31 supplying of ms rods and chuck nut (complete set) fordifferent sizes ofsluice valve and should be supplie dasaccording tosizeofchecknutincluding material for the following sizes. 32 sluice valve size 80mm 33 sluice valve size 100mm 34 sluice valve size 125mm 35 sluice valve size 150mm 36 sluice valve size 200mm 37 sluice valve size 250mm 38 makingreducerpumppiecewithheavy dutypipes (class-b) and flange (asper table-d) including cutting of pipe, thre ading welding and ms stripfor length - 100 mm, width-20 mmand thickness- 6mm and to be welded around the strip with pipe and flanged. hole in the flange will be standard size and above 15 mm dia. in size. after tightening the pipe3 39 2x2½ dia size (50x65mm) 40 2½dia size (65x80mm) 41 dia size (50x80mm) 42 dia size (50x80mm)