supply installation and commissioning of water mill installation of water mill , the bidder must quote their rate for supply, installation and commissioning of electro mechanical water mill with following requirements: - turbine ( for electrical / mechanical or both type of output ) including all accessories and required civil works ( cross flow / pat, runner dia = 0.20-0.30m ) . - verticalaxis runner including all accessories and required civil works ( mild steel / cast iron / stailess steel ) . - alternator ( synchronous single phase 240v, 50hz, 1500rpm ( 1kw, 2kw, 3kw & 5kw ) ) . - drive system ( pulley ( 2nos. ) , v-grooved, c.i. pulley for deriving the generator and other machines, v belt and shaft bearings ) . - electronic load controller, ballast load ( micro controller based elc with digital display for output voltage and ballast load % display suitable upto 5 kw generator ) - monitoring, protection, control, switchgear and metering panel ( control panel with current, voltage, frequency meters, mcbs, phaseindicatorandkwhmeter with all other required protections ) . - floor mill ( isi marked ) with accessories required for smooth running of machine including all accessories and required civil works. ( foundation size 800 mm x 500 mm ) – ( sizes 16 / 18” and 18 / 20” ) - with other necessary requirements complete considering the technical specification given in the tender notice no. e-tender-36 of kreda 2021, ref. no. kreda / wm / 2021 / 1855 dated 03.12.2021. on turnkey basis , the bidder must quote their rate for supply, installation and commissioning of mechanical water mill with following requirements: - turbine ( for mechanical output ) including all accessories and required civil works ( cross flow / pat, runner dia = 0.20-0.30m ) . - verticalaxis runner including all accessories and required civil works ( mild steel / cast iron / stailess steel ) . - drive system ( pulley ( 2nos. ) , v-grooved, c.i. pulley for deriving the generator and other machines, v belt and shaft bearings ) . - floor mill ( isi marked ) with accessories required for smooth running of machine including all accessories and required civil works. ( foundation size 800 mm x 500 mm ) – ( sizes 16 / 18” and 18 / 20” ) . - with other necessary requirements complete considering the technical specification given in the tender notice no. e-tender-36 of kreda 2021, ref. no. kreda / wm / 2021 / 1855 date 03.12.2021 on turnkey basis.