purchase of mill house spares (b) dismantling, repairing and fitting of cane cutter assembly along with trial and purchase of cane cutter assembly spares i.e. hub etc. (as per requirement) . , purchase of mill house spares (b) dismantling, repairing and fitting of cane cutter assembly along with trial and purchase of new hubs (as per requirement).: , bridge wheel gear 64 teeth , bridge driving shaft 16 teeth crane no.-1 material- en9 ( bearing use-22211) , gear coupling g.c. -0.02 forged steel made (hightech swastika make) , brake bolt as per sample , pinion shaft 16 teeth lode-unlode en 24 heavy duty, tempered, teeth grinded, as per drawing/sample , hydrolic pump for hyd.grab 7.5ton k2r040/krr045 with shaft key clockwise rotation (danfoss make) made in slovakia , hydraulic cylinder r.h.s as per sample , hydraulic cylinder l.h.s as per sample , gear coupling only of 10 brake drum coupling en 24 heavy duty, tempered, teeth grinded, as per drawing/sample , gear box for cane unloader capacity-10ton load unload tyep (as per sample) , pinion (gear) 21 teeth en 24 heavy duty, tempered, teeth grinded, as per drawing/sample , gear 68 teeth of load unload grade 3b gear 68 teeth of load unload grade 3b as per sample , (b) dismantling, reparing and fitting of cane cutter assembly along with trial (i) dismanling of all hubs with its bearing, fly wheel, coupling etc. from cane cutter shaft.(as per requirement) , (ii) ultrasonic and dp testing of old shaft , (iii) fitting of all hubs with its bearings fly wheel, coupling etc. on cane cutter shaft as per requirement) , (iv) dynamic balancing of cane cutter assembly (as per requirement) , (v) checking and repairing of old hubs (as per requirement) , purchase of new hubs