supply and installation of lab equipment two rota vapour for ceps supply and installation of lab equipment two rota vapour for ceps . , laying and jointing pvc pipe. heading , specifications of rota vapour are as follows: • end stop position: the push button height adjustment ( electronic lift ) • immersion angel adjustment with 6 or more angles • automatic operation sops on power failure ( lifts flask automatically out of heating bath ) • rotation speed 10 – up to 280 rpm or higher • maximum flask load up to 3kg or higher • foam sensor and level sensor are optional • vertical condenser bath should allow the use of water and oil as a heating media up to 200 c. mechanical and electronic over-temperature control ( cuts off power when actual temperature exceeds set temperature and also set point ) display should be digital, displays all operating parameters ( indicates set and actual values of heating bath temperature, rotation speed and lift position ) pump: the vacuum pump should be chemically resistant ptfe diaphragm pumps with low noise emission. the suction capacity should be 1.8m3 / h or higher re-circulating chiller: temperature range – 10 c to 25 c with flow rate 2.5l / min. or higher. with digital display ( resolution 0.1 c )