tender for provision of led light fittings along with allied accessories on existing poles in various locations in ward169 under central zone mcd.; 1 supply of xlpe insulated pvc sheathed al. conductor un-armoured cable 1.1kv grade conforming to is-7098 of following size:-2c*4 sqmm 2 supply and fixing of 32mm dia x 1 meter long g.i. pipe (medium class) bracket for mounting of fluorescent/hpmv/hpsv street light fitting on pole including bending the pipe to the required shape , 2 nos 25mm x 6mm flat iron clamps with nuts, bolts and washer , painting the flat iron with primer and finish paint etc. as reqd. 3 laying of one number pvc insulated and pvc sheathed/xlpe power cable of 1.1 kv grade of following size in the existing masonry open duct as required. up to 35 sqmm 4 supplying and drawing following sizes of frls pvc insulated copper conductor, single core cable in the existing surface/ recessed steel/ pvc conduit as required. 3 x 1.5 sq. mm 5 supplying, installation, testing & commissioning of street light led fixture, powder coated pressure die cast aluminum body with built in or separate driver as per the requirement with driver efficiency >85%, input voltage: 140-270 volt ac, freq 50/60hz, operating temp range-15deg to50 deg centigrade, internal surge protection of 5 kv l,n,e as per iec 61000-4- 5,driver efficiency>85%, thd<10% as per iec 61000-3-2,p.f.≥0.95, ip- 66,ik-10, cri >80 , under voltage and over voltage protection,emi- emc as percispr-15,lenses for beam angle as per ies na type i/ii/iii as per the width of the road and the project requirement., suitable to fit in up to 65mm dia pipe, life time (led,driver & electrical circuitry) of minimum 50000 burning hours with 70% of initial lumen maintained till life ends as per lm80 extrapolation ies tm-21-11 report , cct 3000°k /4000°k / 5700°k /6000°k /6500°k (as per ansi bin) , sdcm (standard deviation color matching) <5, maximum power consumption should not more than the specified rating and fixture shall be of relevant bis standard complete in all respect i/c connections with 1.5 sq mm frls, pvc insulated copper conductor single core cable and earthing etc.as required with minimum 5year oem warranty. system lumen efficacy >135 lm/watt output . lm79 & lm80 test report from nabl lab for all testing required for led fixtures as per bis shall be submitted. shape size and cct shall be as approved by engineer-in-charge as per requirement. (thermal management: heat sink of aluminum temperature shall not rise above 90°c). 45 watt