tender for improvements to the view cutter for cisf quarter guard at hwp (m) colony.; 1 earth work in excavationin all kinds of soil by mechanical means (hydraulic excavator)/ manual means over areas (exceeding 30 cm in depth, 1.5 m in width as well as 10 sqm on plan) including getting out and disposal of excavated earth lead upto 1.05 km and lift upto 1.5 m,and refilling available excavated earth (excluding rock) in sides of foundations etc. in layers not exceeding 20cm in depth, consolidating each deposited layer by ramming and watering, complete and disposing of all surplus materialswithin premises as per drawings all complete as per specification and as directed ny the engineer in charge.note:- including dewatering if required. 2 felling of trees of the girth above 240 cm (measured at a height of 1 m above ground level), including cutting of trunks and branches, removing the roots and stacking of serviceable material and disposal of unserviceable material, all complete as per specification and as directed by the engineer in charge. 3 demolishing/ dismantling of cement concrete/rr masonry/platser andbrick workcarefullymanually/ by mechanical means including disposal of material to dumping yard in colony with all leads and lifts etc., all complete as per specifications and as directed by the engineer in charge. 4 providing and laying plain cement concrete 1:4:8 (1 cement: 4 sand: 8 stone aggregate) grade, using 40mm and down gauge crushed stone aggregate of approved quality, 43 grade opc cement of acc/ ultratech/ birla a1 or any other approved makein foundations and plinth, under floor etc including ramming, leveling, curing, form work wherever necessary etc. complete as per drawings, specifications and as directed by the engineerin charge. 5 providing and laying reinforced cement concrete 1:1.5:3(1 cement: 1.5 sand: 3 stone aggregate) 43 grade opc cement of acc/ ultratech/ birla a1 or any other approved make with 20 mm and down gauge stone aggregate of approved quality in foundations and plinth, under floor etc including cost of centering, shuttering, ramming, leveling, curing, form work wherever necessary etc. complete as per drawings, specifications and as directed by the engineer. 6 providing, transporting, placing in position of tmt bar reinforcement steel of grade fe 415d/ 500d of jindal/ tata/ sail/ vizag or any other approved make for r.c.c works including straightening, cutting, bending,binding with 16 gauge ms annealed binding wire and welding wherever necessary, providing cover blocks etcall complete as per specification and as directed ny the engineer in charge. 7 providing, fabricating and erecting50 micron gi coatingstructural steel work in built up sections of jindal/ tata/ sail/ vizag or any other approved make using ms channels, angles, flats and louvers etc., including cutting, hoisting welding and fixing in positions as per drawings and all complete as per specification and as directed by the engineer in charge.