tender for the work of pole wedling & plinth of pole under eudd- hathras - straightening of tilted single st poles in the existing lines as per direction of supervising engineer. 2 opening & reinstalling of service cable for pole welding 3 digging of proper size of pit for following work of damaged steel support with the provision of temporary support :-then reinforcement of steel support by welding of 04 nos. 2 feet long m.s. angle iron of 50x50x6 mm. at equal distance around each pole & also welding of these angle iron with each other by providing m.s. flat of size 35x6 mm. in round. 4 construction of round plinth around the s.t. poles / rs joists / rails will be done with cement, sand and concrete in 1:3:6 ratio of size 450 mm. dia & 600 mm height (300 mm. under the ground + 300 mm. the ground). the plinth should be plastered with ½ inch thick cement and sand of ratio 1:4 & taper rounding the upper most part of the plinth. the rate will include all cost of material, labour and t&p etc. for completion of the above work which will be provided by the contractor at his own cost.