tender for tiles and repair work in chandrashekhar park in ward no. 149 - 1 (10.1) providing and fixing precast cement concrete m-20 grade (using mechanical concrete mixer) kerb stone top and bottom width 115 and 165 mm respectively, 250 mm high on 150 mm thick pcc m-10 grade foundation as per design, including fixing at site as per clause 408 of mort&h specification including all material, labour, machinery, lighting, guarding and maintenance of diversion. 2 (4.12) filling with locally available river sand at all levels including watering ramming consolidating and dressing complete including cost of sand. 3 (4.4) construction of embankment with approved material obtained from borrow pit with all lifts and leads, transporting to site, spreading, grading to required slope and compacting by vibratory roller 8-10 tonne to meet requirement of table 300-2 including cost of compensation for earth taken from private land complete as per mort&h specification clause 305. (lead taken upto 5 km) 4 (9.1) providing and laying lean cement concrete 1:4:8 in sub- base over a prepared sub-grade with coarse and fine aggregate conforming to is: 383, the size of coarse aggregate not exceeding 25 mm, aggregate cement ratio not to exceed 15:1, aggregate gradation after blending to be as per table 600-1, cement content not to be less than 150 kg/ cum, optimum moisture content to be determined during trial length construction, concrete strength not to be less than 10 mpa at 7 days, mixed in a batching plant, transported to site, laid with a paver with electronic sensor, compacting with 8-10 tonnes vibratory roller, finishing and curing complete as per clause 601, 112 of mort&h specification including all material, labour, machinery, lighting, guarding and maintenance of diversion. 5 (9.11) providing and fixing of 60mm thick precast cement concrete interlocking paver block casted with rubber moulds in approved reflective colour and design having minimum compressive strength of 300 kg/ sq cm. the cc paving blocks be laid on average 50mm thick bed of coarse sand and the joint is to be filled with fine sand. laying procedure on compacted sub-base as defined. complete job is to be executed as per the instruction of engineer in-charge. the rates to be inclusive of all lead & lifts etc. complete as per specifications.