tender for annual plan-kjp 25-26 (pro no 518/26 ) mynagappally gp-maintenance of lvghs kadappa school-lvghs kadappa maintenance-general civil work -- 1 construction of kitchen , drainage and other maintenance 2 2.8.1:earth work in excavation by mechanical means (hydraulic excavator) /manual means in foundation trenches or drains (not exceeding 1.5 m in width or 10 sqm on plan), including dressing of sides and ramming of bottoms, lift up to 1.5 m, including getting out the excavated soil and disposal of surplus excavated soil as directed, within a lead of 50 m.all kinds of soil 3 4.1.8:providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - all work up to plinth level:1:4:8 (1 cement : 4 coarse sand (zone-iii) derived from natural sources : 8 graded stone aggregate 40 mm nominal size derived from natural sources) 4 4.1.6:providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - all work up to plinth level:1:3:6 (1 cement : 3 coarse sand (zone-iii) derived from natural sources : 6 graded stone aggregate 40 mm nominal size derived from natural sources) 5 4.1.3:providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - all work up to plinth level:1:2:4 (cement : 2 coarse sand (zone-iii)derived from natural sources : 4 graded stone aggregate 20 mm nominal sizederived from natural sources) 6 7.1.1:random rubble masonry with hard stone in foundation and plinth including levelling up with cement concrete 1:6:12 (1 cement : 6 coarse sand : 12 graded stone aggregate 20 mm nominal size) up to plinth level with:cement mortar 1:6 (1 cement : 6 coarse sand) 7 5.1.2:providing and laying in position specified grade of reinforced cement concrete, excluding the cost of centering, shuttering, finishing and reinforcement - all work up to plinth level:1:1:5:3 (1 cement 1.5 coarse sand :3 graded stone aggregate 20 mm nominal size derived from natural sources) 8 50.6.1.5:solid block masonry using pre cast solid blocks ( factory made) of size 30x20x20cm or nearest available size confirming to is 2185 part i of 1979 for super structure up to floor two level thickness 20cm and above in: cm 1:6 ( 1 cement : 6 coarse sand) etc complete 9 50.6.2.1:solid block masonry using pre cast solid blocks (factory made) of size 30x20x15 cm or nearest available size confirming to is 2185 part i of 1979 for foundation and plinth with thickness 15cm in: cm 1:6 ( 1 cement :6 coarse sand) etc complete 10 5.3:reinforced cement concrete work in beams, suspended floors, roofs, having slope up to 15°landings, balconies, shelves, chajjas, lintels, bands, plain window sills, staircases and spiral stair cases up to floor five level excluding the cost of centering, shuttering, finishing and reinforcement, with1:1.5:3 (1 cement : 1.5 coarse sand (zone iii)derived from natural sources: 3 graded stone aggregate 20 mm nominal sizederived from natural sources). 11 5.22a.6:steel reinforcement for r.c.c work including straightening, cutting, bending, placing in position and binding all complete above plinth level.thermo - mechanically treated bars of grade fe-500d or more 12 5.9.3:centering and shuttering including strutting, etc. and removal of form for:suspended floors, roofs, landings, balconies and access platform 13 5.9.5:centering and shuttering including strutting, etc. and removal of form for:lintels, beams, plinth beams, girders bressumers and cantilevers 14 13.1.1:12 mm cement plaster of mix:1:4 ( 1 cement : 4 fine sand) 15 13.16.1:6 mm cement plaster of mix:1:3 ( 1 cement : 3 fine sand) 16 13.7.2:12 mm cement plaster finished with a floating coat of neat cement of mix:1:4 ( 1 cement : 4 fine sand) 17 13.43.1:applying one coat of water thinnable cement primer of approved brand and manufacture on wall surface:water thinnable cement primer 18 13.50.1:applying priming coat:with ready mixed pink or grey primer of approved brand and manufacture on wood work (hard and soft wood) 19 13.60.1:wall painting with acrylic emulsion paint of approved brand and manufacture to give an even shade:two or more coats on new work 20 13.61.1:painting with synthetic enamel paint of approved brand and manufacture to give an even shade:two or more coats on new work 21 11.37:providing and laying ceramic glazed floor tiles of size 300x300 mm (thickness to be specified by the manufacturer) of 1st quality conforming to is : 15622 of approved make in colours such as white, ivory, grey, fume red brown, laid on 20 mm thick cement mortar 1:4 (1 cement : 4 coarse sand), jointing with grey cement slurry @ 3.3 kg/sqm including pointing the joints with white cement and matching pigment etc., complete 22 8.31:providing and fixing ist quality ceramic glazed wall tiles conforming to is: 15622 (thickness to be specified by the manufacturer), of approved make, in all colours, shades except burgundy, bottle green, black of any size as approved by engineer-in- charge, in skirting, risers of steps and dados, over 12 mm thick bed of cement mortar 1:3 (1 cement : 3 coarse sand) and jointing with grey cement slurry @ 3.3kg per sqm, including pointing in white cement mixed with pigment of matching shade complete. 23 50.9.1.1:providing wood work in frames of doors, windows, clerestory windows and other frames, wrought framed and fixed in position with hold fast lugs or with dash fasteners of required dia & length (hold fast lugs or dash fastener shall be paid for separately), using good quality anjili wood /jack wood 24 50.9.3.1:providing and fixing paneled or paneled and glazed shutters for doors, windows and clerestory windows, 30 mm thick shutters including isi marked m.s. pressed butt hinges bright finished of required size with necessary screws, excluding paneling which will be paid for separately, all complete as per direction 0f engineer in- charge. using anjili/ jack wood 25 50.9.4.1:providing and fixing paneling or paneling and glazing in paneled or paneled and glazed shutters for doors, windows and clerestory windows (area of opening for panel inserts excluding portion inside grooves or rebates to be measured) paneling for paneled or paneled and glazed shutters 25 mm to 40 mm thick using good quality anjili/ jack wood 26 50.9.6.1:providing and fixing glazed shutters for doors, windows and clerestory windows using 4 mm thick float glass panes including isi marked m.s. pressed butt hinges bright finished of required size with necessary screws. using anjili wood / jack wood 30 mm thick shutters 27 14.29:providing and fixing m.s. round or squre bars with m.s. flats at required spacing in wooden frames of windows and clerestory windows. 28 17.26.1:providing and fixing kitchen sink including making all connections excluding cost of fittings.white glazed fire clay sink of size 600x450x250 mm 29 17.28.1.1:providing and fixing p.v.c. waste pipe for sink or wash basin including pvc. waste fittings complete.semi rigid pipe32 mm dia 30 50.18.9.7.2:providing and fixing pvc pipes includings jointing of pipes with one step pvc solvent cement, trenching, refilling & testing of joints complete as per direction of engineer in charge.63 mm dia 4 kgf/cm2 31 50.18.9.12.2:providing and fixing pvc pipes, fittings including fixing the pipe with clamps at 1.00 m spacing. this includes jointing of pipes & fittings with one step pvc solvent cement and testing of joints complete as per direction of engineer-in-charge 20 mm dia 10kgf/cm2 external work- exposed on wall 32 od304182/2025-2026:providing and fixing pvc tap 33 9.62.2:providing and fixing isi marked oxidised m.s. sliding door bolts with nuts and screws etc. complete : (copper oxidized as per is 1378).250x16mm 34 9.63.2:providing and fixing isi marked oxidised m.s. tower bolt black finish, (barrel type) with necessary screws etc. complete : (copper oxidized as per is : 1378)200x10 mm 35 9.63.3:providing and fixing isi marked oxidised m.s. tower bolt black finish, (barrel type) with necessary screws etc. complete : (copper oxidized as per is : 1378)150x10 mm 36 14.35.4:providing and fixing finished brass hard drawn hooks and eyes:150 mm 37 14.35.5:providing and fixing finished brass hard drawn hooks and eyes:100 mm 38 10.1:structural steel work in single section, fixed with or without connecting plate, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer all complete. 39 od305903/2025-2026:providing and laying 60 mm thick factory made cement concrete interlocking paver block of m - 30 grade made by block making machine with strong vibratory compaction, of approved size, design & shape, laid in required colour and pattern over and including 50 mm thick compacted bed of 6mm chips filling the joints with fine sand etc. all complete as per the direction of engineer-in-charge.