annual plan-08/25-26-renovation of panchayath office-general civil work -- 1 renovation of panchayath office 2 od227281/2025-2026:providing and fixing anodisedaluminium work ( minimum thickness of anodising 15 micron) consisting of tee /angle sections, of approved make conforming to is : 733 in frames of false ceiling including aluminium angle cleats with necessary c.p brass/ stainless steel sunk screws, aluminium perimeter angles fixed to wall with stainless steel rawl plugs @ 450 mm centre to centre and fixing the frame work to g.i level adjusting hangers 6 mm dia. with necessary cadmium plated machine screws all complete as per approved architectural drawings and direction of the engineer-in-charge ( level adjusting hangers, ceiling cleats and expansion hold fasteners to be paid for separately ). 3 50.12.4.2:providing and fixing false ceiling with 7.5 mm thick pvc wooden grains panel board ceiling of approved quality in aluminium frame work with necessary screws etc complete ( aluminium frame work shall be paid separately) 4 16.68:providing and laying 60 mm thick factory made cement concrete interlocking paver block of m - 30 grade made by block making machine with strong vibratory compaction, of approved size, design & shape, laid in required colour and pattern over and including 50 mm thick compacted bed of coarse sand, filling the joints with fine sand etc. all complete as per the direction of engineer-in-charge. 5 od231984/2025-2026:providing and laying 60 mm thick factory made cement concrete departmentalinterlocking paver block of m - 30 grade made by block making machine with strong vibratory compaction, of approved size, design & shape, laid in required colour and pattern over and including 50 mm thick compacted bed of coarse sand, filling the joints with fine sand etc. all complete as per the direction of engineer-in-charge. 6 od231988/2025-2026:providing and fixing precoated galvanised iron profile sheets (size, shape and pitch ofcorrugation as approved by engineer-in-charge) 0.35 mm (+0.05%), total coatedthickness with zinc coating 120 grams per sqm as per is: 277, in 240 mpa steel grade, 5-7 microns epoxy primer on both side. of the sheet and polyester top coat 15-18 microns.sheet should have protective guard film of 25 microns minimum to avoid scratchesduring transportation and should be supplied in single length upto 12 metre or as desiredby engineer-in-charge. the sheet shall be fixed using self drilling/self tapping screws ofsize (5.5x55mm) with epdm seal, complete upto any pitch in horizontal/ vertical orcurved surfaces, excluding the cost of purlins, rafters and trusses and including cutting tosize and shape wherever required. 7 10.16.1:steel work in built up tubular (round, square or rectangular hollow tubes etc.) trusses etc., including cutting, hoisting, fixing position and applying a priming coat of approved steel primer, including welding and bolted with special shaped washers etc. complete.hot finished welded type tubes 8 13.99.1:painting with synthetic enamel paint of approved brand and manufacture ofrequired colour to give an even shade :one or more coats on old work 9 od259736/2025-2026:supplying and fixing pvc gutter 160mmsize rectangular section with all necessary fitting end piece etc complete 10 od259460/2025-2026:engaging labour 11 50.18.9.18.1:providing and fixing pvc pipes including fixing the pipe with clamps/clips at 1.00 m spacing. this included jointing of pipes with one step pvc solvent cement and testing of joints complete as per direction of engineer-in-charge 75 mm dia 6kgf/cm2 - external work- exposed on wall