tender for annual plan-smn 292/24-25-completion of prasannapuram subcentre-general civil work - balance work 2 5.9.16.1:centering and shuttering including strutting, etc. and removal of form for:edges of slabs and breaks in floors and wallsunder 20 cm wide 3 21.3.1:providing and fixing glazing in aluminium door, window, ventilator shutters and partitions etc. with epdm rubber / neoprene gasket etc. complete as per the architectural drawings and the directions of engineer - in -charge. ( cost of aluminium snap beading shall be paid in basic item):with float glass panes of 4.0 mm thickness 4 50.9.15.4:providing and fixing iron hooks and eyes: 150 mm 5 9.55.2:providing and fixing isi marked m.s. pressed butt hinges bright finished with necessary screws etc, complete:100x58x1.90mm. 6 11.49.2:providing and laying vitrified tiles in floor with different sizes (thickness to be specified by the manufacturer), with water absorption less than 0.08% and conforming to is : 15622, of approved brand & manufacturer, in all colours and shade, laid with cement based high polymer modified quick set tile adhesive (water based) conforming to is : 15477, in average 6 mm thickness, including grouting of joints (payment for grouting of joints to be made separately).size of tiles 600x600 mm 7 10.16.1:steel work in built up tubular (round, square or rectangular hollow tubes etc.) trusses etc., including cutting, hoisting, fixing position and applying a priming coat of approved steel primer, including welding and bolted with special shaped washers etc. complete.hot finished welded type tubes 8 21.5:providing and fixing powder coated aluminium work ( minimum thickness of powder coating 50 micron) consisting of tee /angle sections, of approved make conforming to is : 733 in frames of false ceiling including aluminium angle cleats with necessary c.p brass/ stainless steel sunk screws, aluminium perimeter angles fixed to wall with stainless steel rawl plugs @ 450 mm centre to centre and fixing the frame work to g.i level adjusting hangers 6 mm dia. with necessary cadmium plated machine screws all complete as per approved architectural drawings and direction of the engineer-in-charge ( level adjusting hangers, ceiling cleats and expansion hold fasteners to be paid for separately ). 9 50.12.4.2:providing and fixing false ceiling with 7.5 mm thick pvc wooden grains panel board ceiling of approved quality in aluminium frame work with necessary screws etc complete ( aluminium frame work shall be paid separately) 10 50.18.9.13.2:providing and fixing pvc pipes, fittings including fixing the pipe with clamps at 1.00 m spacing. this includes jointing of pipes & fittings with one step pvc solvent cement and testing of joints complete as per direction of engineer-in-charge 25 mm dia 10 kgf/cm2- external work - exposed on wall 11 21.1.2.2:for shutters of doors, windows & ventilators including providing and fixing hinges / pivots and making provision for fixing of fittings wherever required including the cost of epdm rubber/ neoprene gasket required (fittings shall be paid for separately)powder coated aluminium (minimum thickness of powder coating 50 micron) 12 50.18.9.17.2:providing and fixing pvc pipes including fixing the pipe with clamps/clips at 1.00 m spacing. this includes jointing of pipes with one step pvc solvent cement and testing of joints complete as per direction of engineer-in-charge 63 mm dia 4 kgf/cm2- external work - exposed on wall 13 4.1.8:providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - all work up to plinth level:1:4:8 (1 cement : 4 coarse sand : 8 graded stone aggregate 40 nominal size)