tender for plastering and repainting of fencing and providing a new steel gate at port guest house; 1 plastering the brick work 15 mm thick in cement mortar 1:5 (plastering sand (p-sand)) (one cement, five plastering sand (p-sand)) for all faces of walls (even and uneven) in all floors upto full height of the building including necessary scaffolding, racking of masonry joints, cleaning, curing etc., complete complying with aiss and as directed by the departmental officers. 2 applying one coat of alkali resistant primer and two coats of apex - exterior emulsion paint ofapproved colour and quality over the new wall surface in all floors to give an even shade after thoroughly brushing the surface free frommortar droppings and other foreign matter and also including preparing the surface even and sand paperes smooth including all materials, labour, brushes, scaffolding, etc., complete complying with aiss and as directed by the departmental officers. 3 applying one coat of red oxide primer over new steel and other metal surfaces including preparingthe surface by thoroughly cleaning oil, grease, dirt and other foreignmatter and scoured with wire brushes, fine steel wool, scrapers and sand paper etc.,complete complying with aiss and as directed by the departmental officers 4 supplying the structural steel, ms flats, square rods, angles, channels etc., for vertical members / bracing /stiffeners / base plates or for any other usage as a structural member, fabricating, welding and erecting the frame work in position at the locations shown in thedrawing including all labour, materials, conveyance, tools & plants, etc., complete and as directed by the departmental officers (note : 1. while fabricating, necessary holes and bolt & nut shall be provided at no extra cost in the structural members. 2. in case, the specified ms section is not available in the market, the nearest alternative section may be used after approval of the engineer). 5 ainting the steel surfaces with two coats of synthetic enamal paint of approved quality (excluding priming coat) on new steel and other metal surfaces with enamel paint, brushing, interior to give an even shade including cleaning the surface of all dirt, dust and other foreign matter including all materials, labour, brushes, etc., complete complying with aiss and as directed by the departmental officers.