tender for work of replacing damaged door frames in house number 6/12, type-4, located in upper dalibagh colony, work of installing mesh doors, work of aluminium partition in balcony for security purposes - providing and fixing isi marked flush door shutters conforming to is : 2202 (part i) nondecorative type, core of block board construction with frame of 1st class hard wood and well matched commercial 3 ply veneering with vertical grains or cross bands and face veneers on both faces of shutters:35 mm thick including isi marked stainless steel butt hinges with necessary screws dar 9.21.1 2 providing and fixing of 35, mm thick up teak wood jali door and window shutter withheavy quality s.s. jali with necessary beading, including supply and fixing of wooden cleats and stopper and including fixing and adjustment of hinges, bolts, locks handles, spring & or otherfitting but excluding their supply etc. painting two coats of black japan on all frame fitting in necessary etc. complete work as per direction of e/i. 3 providing and fixing of aluminium work for doors, window, ventilators and partitions with extruded built up standard tubular sections appropriate z sections and other sections of approved make conforming to is:733 and isl;1285, fixing with dash fasteners of required dia and size, including necessary filling up the gape at junctions, i.e. at top, bottom and sides with required epdm rubber/neorapan gascket etc. aluminium section shall be smooth rust free straight mistred and jointed machanically whrever required including clear angle, aluminium snap beading for glazing/paneling, c.p. brass/stainless steel screws, all complete as per architectural drawing and the directions of engineer-in-charge. (glazing, paneling and dash fasteners to be paid for separately) (for fixed portion) power coated aluminium (minimum thickness of power coating 50 micron) dar-21.1.2.2, 4 providing and fixing float glass panes 6.00 mm thick glass panes, (dar-9.7.7.2) 5 providing and fixing of glazing in aluminium door/window, ventilator shutter and partitions etc, with epdm rubber/ neoprene gasket etc, complete as per the architectural drawings and the direction fo e/i (cost of aluminium snap beading shall be paid in basic item with apc sheet (aluminium power coated sheet). 6 structual steel work riveted bolted or welded in built up section, trusses, builds up gates,framed work lncluding cutting, hoisting, fixing in position and applying a priming coat of approved steel primer all complete. sl.n0-10.2, (rs-75) 7 renewing glass panes, with putty and nails wherever necessary including racking out the old putty: float glass panes of nominal thickness 4 mm (weight not less than 10kg/sqm) dar 14.5.1