tender for repairing of ssk at bangabari sansad iii code- 109470821-1 brick work with ist class bricks in cement mortar (1:6) tabi 2 dinning set for student supplying, fitting & fixing ist quality ceramic tiles in walls and floors to match with the existing work & 4 nos. of key stones (10mm) fixed with araldite at the back of each tile & finishing the joints with white cement mixed with colouring oxid if required to match the colour of tiles including roughening of concrete surface, if necessary or by synthetic adhesive & grout materials etc. with sand cement mortar (1:4) 20 mm thick & 2 mm thick cement slurry at back side of tiles using cement @2.91 kg/sq.m. joint filling using white cement slurry @ 0.20kg/sq.m 3 125 mm. thick brick work with 1st class bricks in cement mortar haif wall dinning hall 4 plaster to wall, floor celling etc with sand and cement morter including rounding off or chamfering corners as directed and ranking out joints includingthroughting, nosing and drip course, scaffolding/staging where necessary with 1:6 cement morter. 15mm thick. in ground floor 5 scraping and removing greasy soot from walls or ceiling of kitchen or similar smoke affected rooms and preparing the surface. ground floor wall deduction for window w1 deduction for window w2 door total 6 (b) priming one coat on timber or plastered surface with synthetic oil bound primer of approved quality including smoothening surfaces by sand papering etc. ground floor wall deduction for window w1 deduction for window w2 door total 7 (a) painting with best quality synthetic enamel paint of approved make and brand including smoothening surface by sand papering etc. including using of approved putty etc. on the surface, if necessary: (a) on timber or plastered surface: with super gloss (hi-gloss)- (il) two coats (white in shade) ground floor wall deduction for window w1 deduction for window w2 door total two door for outside urinal along with fitting, fixing 8 of iron sheet ing & fixing concrete sign board as per irc specification of s * 0 * 750 * 37mm thick made with rcc 1:14:3 with pakur lety stone chips reinforced with double layer irc febric ( 75 * 75 om. mesh) and fixed with necessary nuts & bolts on two rc precast posts 100mm .*150 mm. of height 2.65 m. of which top 750 mm. is of section 100 x 13 mm. and 1.90 metre above gl & 0.75 metre below gl including digging hole, repacking the same with cement concrete 1:3:6 with jhama khoa or with local stone chips etc. complete including painting two coats on both faces lettering sign marks etc. as per direction of the engineer-in-charge. (the rate is inclusive of cost of reinforcement, concrete, shuttering, nuts & bolts, washer etc.complete.)