tender for annual plan-konni g.p 388/2024-25-providing interlocks and construct a shed in krishi office building-general civil work - extention work of exi. krishi office building 2 2.28.1:surface dressing of the ground including removing vegetation and in-equalities not exceeding 15 cm deep and disposal of rubbish, lead up to 50 m and lift up to 1.5 m.all kinds of soil 3 16.68:providing and laying 60 mm thick factory made cement concrete interlocking paver block of m - 30 grade made by block making machine with strong vibratory compaction, of approved size, design & shape, laid in required colour and pattern over and including 50 mm thick compacted bed of coarse sand, filling the joints with fine sand etc. all complete as per the direction of engineer-in-charge. 4 4.1.3:providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - all work up to plinth level:1:2:4 (cement : 2 coarse sand (zone-iii) : 4 graded stone aggregate 20 mm nominal size) 5 2.6.1:earth work in excavation by mechanical means (hydraulic excavator)/manual means over areas (exceeding 30 cm in depth, 1.5 m in width as well as 10 sqm on plan) including disposal of excavated earth, lead up to 50 m and lift up to 1.5 m, disposed earth to be levelled and neatly dressed.all kinds of soil 6 10.2:structural steel work riveted, bolted or welded in built up sections, trusses and framed work, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer all complete. 7 50.10.2:steel work for purlin/single section with g i pipes including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer, including welding and bolted with special shaped washers etc. complete 8 od491284/2024-2025: providing and fixing precoated galvanised iron profile sheets (size, shape and pitch ofcorrugation as approved by engineer-in-charge) 0.35 mm (+0.05%), total coatedthickness with zinc coating 120 grams per sqm as per is: 277, in 240 mpa steel grade, 5-7 microns epoxy primer on both side. of the sheet and polyester top coat 15-18 microns.sheet should have protective guard film of 25 microns minimum to avoid scratchesduring transportation and should be supplied in single length upto 12 metre or as desiredby engineer-in-charge. the sheet shall be fixed using self drilling/self tapping screws ofsize (5.5x55mm) with epdm seal, complete upto any pitch in horizontal/ vertical orcurved surfaces, excluding the cost of purlins, rafters and trusses and including cutting tosize and shape wherever required. 9 od491286/2024-2025: supply and fixing pvc square rain water gutter path including fixing, by using ms flat support etc...complete 10 50.18.9.17.1:providing and fixing pvc pipes including fixing the pipe with clamps/ clip at 1.00 m spacing . this includes jointing of pipes with one step pvc solvent cement and testing of joints complete as per direction of engineer-in-charge 63 mm dia 6 kgf/cm2 - external work - exposed on wall