tender for road safety work under maintenance - providing and laying of hot appiled thermoplastic compound 2.5 mm thick including reflectorising glass beads @ 250 gms per sqm area, thickness of 2.5 mm is exclusive of surface applied glass beads as per irc: 35 the finished surface to be level, uniform and free from streak and holes 2 thermoplastic marking of 300 mm wide and 5 mm height, at 1000 mm apart (one set is of 6 strips). 5 mm height is achieved through two applications of thermoplastic, applied at an interval not less than 1 hour after the previous layer gets solidified.(repeated bars) morth-803(8.130)-base 3 supply & fixing of pavement maker (cat eye) type z-astmd-4956-04 avery dennison/3-m (usa make) consisting of asa plastic housing fitted with tighty adherent ploiting compound. the housing shall contain prismatic two glass covered prismatic reflective face to reflect incident light i/c all tax.(with shank) 4 linear delineator system (lds)supply & fixing of linear delineator system (lds) panels made of micro prismatic retro reflective sheeting type xl duly laminated on thin aluminium foil to a unique corrugated shape to provide retro reflection across wide range of observations and external angles. eatch lds panel should be of nominal length of 33 inch and each ridge shall be approximately 0.34 inch high. each lds panel is to be firmly fixed on existing concrete/brick work with 16 nos fastner/ screw 5 supply and fixing of retroreflective high intensity informatory sign board/ cautionary sign board etc. as per morth specification. stop sign board 6 retro-reflectorised traffic sign as per irc-67-2012providing and fixing of retro- reflectorised cautionary, mandatory and informatory sign as per irc :67-2012 made of high intensity grade sheeting type-iv vide clause 801.3, fixed over aluminium sheeting, 1.5 mm thick supported on a mild steel angle iron post 75 mm x 75 mm x 6 mm firmly fixed to the ground by means of properly designed foundation with m15 grade cement concrete 45 cm x 45 cm x 60 cm, 60 cm below ground level as per approved drawing. the retro reflective sheeting shall be tested for a certificate of having the sheeting tested for coefficient of retro reflection, daytime colour and luminance, 3 years out door weathering and its having passed these tests shall be obtained from international/ governmentlaboratory institute by the manufacturer of the sheeting and in case the certificate is obtained from international condition, it should also be obtained from indian condition within 3 years of launching of product by the manufacture in abroad alternatively, a certificate conforming to astm specification (d 4956-09) on artificial accelerated weathering requirements from a reputed laboratory in india can be accepted provisionally in such athe employer/client, if so desires could seak for a performance guarantee which would be released after receipt of certificate meeting the requirement of three years outdoor weathering of the sheeting as per irc 67.2012 legends, letters numerals and borders etc should be as per morth specification no-801.3.7 proof of the same in form of government report shall be uploaded while quoting tender. as per morth-801 (8.4 (x) 30 cm×90 cm(left/right) object hazard.