bids are invited for conducted noise emission measurement setup- part 1 - frequency range - minimum 9 khz, upto 3 ghz or abovecompliance standards -cisper-25, cisper 16-1-2, mil-std, preferably essential automotive standards for power converterssetup mode - benchtop instrument with in built operating system.should be provided with artificial network for ac power mains, artificial network for dc power mains, and transient limiter , conducted noise emission measurement setup- part 2 - pre-amplifier - neededresolution bandwidth (-3db) - 1 hz to 3 mhz, 4 mhz, 5 mhz, 6 mhz, 8 mhz, in 10% steps of band, and selectivity (-60 db/ -3 db): 4:1:1 nominalaging rate of spectrum analyzer frequency -± 1 x 10¯6 / year. , conducted noise emission measurement setup- part 3 - frequency counter resolution - 0.001 hz, andfrequency span (zero span), 10 hz to max. frequency of instrumentvideo bandwidth -1 hz to 3 mhz, 4, 5, 6 mhz, 8mhz in 10% steps and wide open amplitude max input level for protection = 30 dbmfrequency span should have 10 hz to 3 ghz.or above , conducted noise emission measurement setup-part4 - bandwidth analysis capability - 10 mhz standard or abovesweep point range - 1 to 40001video bandwidth: 1 hz to 3 mhz, 4, 5, 6 mhz, 8mhz in 10% steps and wide opendynamic average level noise: typically -137 dbm , conducted noise emission measurement setup-part5 - trigger:free run, line, video, external 1, rf burst, periodic timertrace detector: normal, peak, sample, negative peak, log power average, rms average, and voltage average , conducted noise emission measurement setupthree-phase induction motor-part6 - phase noise: noise sidebands (cf = 1 ghz) at offset 10 khz: -110dbc/hzmeasurements:channel power, occupied bw, adjacent channel power, ccdf, harmonic, distortion, burst power , conducted noise emission measurement setup - part7 - desired features for conducted noise measurement:- built-in cispr and mil-std compliant bandwidths, detectors and band presets and automated testing