sitc of mortuary cabinet supply, installation, testing and commissioning of mortuary cabinet (including all ancillary civil and electrical works) , supplying and laying true to line and level vitrified tiles of approved brand (size not less than 600 mm x 600 mm x 10 mm thick) in floor, skirting etc. set in 20 mm sand cement mortar (1:4) and 2 mm thick cement slurry back side of tiles using cement @ 2.91kg./sqm or using polymerised adhesive (6 mm thick layer applied directly over finished artificial stone floor/mosaic etc without any backing course) laid after application slurry using 1.75 kg of cement per sqm below mortar only, joints grouted with admixture of white cement and colouring pigment to match with colour of tiles / epoxy grout materials of approved make as directed and removal of wax coating of top surface of tiles with warm water and polishing the tiles using soft and dry cloth upto mirror finish complete including the cost of materials, labour and all other incidental charges complete true to the manufacturers specification and direction of engineer-in-charge. , providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - all work up to plinth level : 1:2:4 (1 cement : 2 coarse sand (zone-iii) derived from natural sources : 4 graded stone aggregate 40 mm nominal size derived from natural sources) , brick work with common burnt clay f.p.s. (non modular) bricks of class designation 7.5 in foundation and plinth in cement mortar 1:4 (1 cement : 4 coarse sand) , 20 mm cement plaster of mix : 1:4 (1 cement: 4 coarse sand) , supplying and filling in plinth with sand under floors, including watering, ramming, consolidating and dressing complete. , steel work welded in built up sections/ framed work, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer using structural steel etc. as required in gratings, frames, guard bar, ladder, railings, brackets. , painting with best quality synthetic enamel paint of approved make and brand including smoothening surface by sand papering etc. including using of approved putty etc. on the surface, if necessary : , sitc of electrical work internal including lighting arrangment , supply and installation of 4cx25 sqmm cable , sitc of rolling shutter as per room size 10 feet x 12 feet , primer and painting of wall and roof , supply and installation of mortuary cabinet of two bodies with outside body and inside tank made of 304 grade steel sheet with single emerson make compressor unit with sliding type strectchers air cooled condenser unit with evaporator coil with anti freeze fan with digitally operated temprature sensor for better accuracy of temperature.