dy at right bhola at km 14.400 to km 17.300 tak work dy at right bhola at km 14.400 to km 17.300 tak work wbm - 2 providing, laying, spreading and compacting stone aggregates of specific sizes to water bound macadam ii specification i/c spreading in uniform thickness, hand packing rolling with three wheel 80-100 kn static roller in stages tp proper grade and camber mord specification 405.2 3 wbm - 3 providing, laying, spreading and compacting stone aggregates of specific sizes to water bound macadam iii specification i/c spreading in uniform thickness, hand packing rolling with three wheel 80-100 kn static roller in stages tp proper grade and camber mord specification 405.3 4 brick lining on both side of the road of m-150 bricks 7 cm wide 11 cm deep, laid with mud mortar including labour & supply of bricks finished to the required] template and in proper alignment and also including dressing and ramming the excavated earth as directed by the engineer in charge 5 providing and laying prime coat with bitumen emulsion (ss-a) onprepared surface of granular base inculding cleaning of road surfafe and spraying primer at the of0.60 kg/sqm using mechnical means as technical specification clause 502 6 providing and applying tack coat with bitumen vg-10 grade using bitumen pressure distributer at the rate of 0.30 kg. per sqm on the prepared granular surface treated with primer & cleaned with hydraulic broom as per technical specification clause 503. 7 providing and laying and rolling of open - graded premix carpet of 20 mm thickness composed of 13.2 mm to 5.6 mm aggregates using vg-10 grade bitumen to required line, grade and level to serve as wearing course on a previously prepared base by manual mord specification clause 508 8 providing and applying seal coat by manual means with 80/100 grade bitumen sealing the voids in bitumens surface laid to the specified levels grade and cross fall using type c as per technical specification clause 510. 9 earthwork in filling for repair and strengthening of damaged bank including 1.50 m lift and lead upto 30 m also with ramming dressing and manual compaction of surface to the required level and slope etc. complete 10 providing and applying 2.5 mm thick road marking strips (retro reflective) of specified shade/ colour using hot thermoplastic material by fully/ semi automatic thermoplastic paint applicator machine fitted with profile shoe, glass beads dispenser, propane tank heater and profile shoe heater, driven by experienced operator on road surface including cost of material, labour, t&p, cleaning the road surface of all dirt, seals, oil, grease and foreign material etc. complete as per direction of engineer-in-charge and accordance with applicablespecifications.