job work for fabrication and testing of electrical sensors , multimode microplate reader , fabrication of electricals ionisation pins ( dia . 1 . 0mm . 1 . 5mm ) as per attached scope of work at appendix-a , connectorisation and preparation of electrical signal cables and preparation of cable looms as per attached scope of work at appendix-a , inspection and testing of fabricated cable loom sets s as per attached scope of work at appendix-a , cutting of ms , perspex , nylon rods & sheets to various sizes as as per attached scope of work at appendix-a , laying of electrical coaxial data recording cables in the routine trial work . laying and connection of cable looms from control room to trial site . placement of ms sheet and strawboard setup as per trial setup for routine trials as as per attached scope of work at appendix-a , mounting of sensor and connecting trial store to data acquisition system as as per attached scope of work at appendix-a , checking electricals connectivity of cable loom after laying in each trials as as per attached scope of work at appendix-a , fabrication of optical sensors- polishing of steel tubes and optical fiber to achieve flat surface , cutting and polishing of optical fibre of desired size , assembling of steel tube and fibre to maintain required air gap between the two as as per attached scope of work at appendix-a , grouting of gi pipe of dia 50mm and length 6m by digging hole of 7cm dia and depth 60 cm and filling with soil anchoring with two supports . gi pipe has to be removed after the trial work . as as per attached scope of work at appendix-a