tender for asi quarters at dhama for the year 22-23 - earth work excavation in hard soil in foundation and plinth including rough dressing and levelling the bed and depositing the excavated earth away from the work site with all leads and lifts including cost of all labour and t&p required for the work and etc. complete in all respect and as per the direction by the engineer-in-charge. 2 filling in foundation and plinth with sand in layers well watered and rammed including cost, conveyance, royalty of all the materials required for the work labour with t&p etc. complete in all respect as per specification and direction of the engineer-in-charge. 3 cement concrete of proportion ( 1:3:6 ) in foundation and plinth using 4cm size clean hard black granite metal of approved quality from approved quarry including hoisting, lowering and laying in layers not exceeding 15cm thick to the required level, ramming watering and curing etc.complete including cost, conveyance, royalty taxes of all the materials required for the work with all labour, t&p etc. complete in all respect as per specification and direction of the engineer-in-charge. 4 cement concrete ( 1:2:4 ) with 12mm size cbhg chips including hoisting and laying including cost, carriage, royalty and curing etc complete as per specification and direction of the engineer-in-charge. 5 reinforced concrete of proportion ( 1:1.5:3 ) using 20mm size clean hard black granite metal of approved quality from approved quarry including hoisting, lowering and laying in layers not exceeding 15cm thick to the required level, ramming watering and curing etc.complete including cost, conveyance, royalty taxes of all the materials required for the work with all labour, t&p etc. complete in all respect as per specification and direction of the engineer-in-charge. ( column base ) 6 column 7 providing, straightening, cutting bending, binding and tying of ms / ts rods ( tata make ) in proper slope and position including all cost and labour etc;complete as per direction of the engineer-in-charge. 8 supplying, fitting, fixing of iron angle including fitting, fixing etc. complete in all respect as per specification and direction of the engineer-in-charge. 9 supplying, fitting, fixing of barbed wire including fitting, fixing etc. complete in all respect as per specification and direction of the engineer-in-charge. 10 providing, fitting and fixing steel angle iron window frame with m.s grill manufactured from standard rolled steel angle section 40 mmx 40 mmx 6 mm cornered of the frame duly metered and electrically welded with fish tailed hold fasts made out of m.s. flats of size 200 mm x 50 mm x 30 mmx 5 mm thick at the rate of 4 nos per frame with m.s hinges of size 75 mm & 14 swg thick at the rate of 3 nos for each single leaf shutter tower bolt ring & m.s grill made of 19 mm x 5 mm flat properly welded to the window frame with one coat of anticorrosive red oxide zinc chrome primer including 1% cess as per direction of engineer in charge. 11 painting two coats over a coat of priming with approved paint and primer on wood and iron work including cost of paint and primer etc complete as per specification and direction of the engineer-in-charge.