tender for job work; repair / maint of eicher 10.75 veh ba no. 03d154732e under ge ( east ) jrc. opening / removal of following unserviceable parts from vehicle and replacing with new parts for proper functioning of the vehicle and testing by officer-in-charge. 1 comprehensive maint and servicing of the eicher vehicles, checking the serviceability of the vehicle oiling, engine tuning, overhauling fixture accessories replacement of first moving parts changing oil ( engine oil will be provided by dept ) , maint of battery with electrolyte solution, distilled water, wheel alingnment, change of wheel greasing, greasing of all mechanical moving parts, checking of the battery charging system. each job 1 2 fuel filter ( primary & secondery ) set 1.00 3 oil filter each 1.00 4 coolant ltr 1.50 5 wiper links & arm each 2.00 6 glass regulator machine each 1.00 7 opening of injectors, servicing & cleaning of injector to remove any dirt, choking and fixing in position for trouble free starting and running each job 1 8 opening of fuel tank, cleaning / rinsing and removing dirt / unwanted particles and re-fixing in position. each job 1 9 taking down the existing defective fuel injection pump ( fip ) alongwith injector for the eicher vehicle engine and replacement of following spares and calibration of fip along with governer and refixing in same position and testing of full load checking of pressure and checking the solinoid coil complete all as specified and directed by the engineer-in-charge each job 1 10 pump repair kit each 1 11 rotary pump pipe ( inlet & out let ) each 2 12 bush set of 2 1 13 taking down the existing defective alternator from vehicle and replacement of worn out spares like rotor , field coil, rectifier, electronic regulator with carbon brush with holder, refixing in same position and testing complete all as specified and directed by the engineer-in-charge each job 1 14 repair to vehicle drive system and checking of parts such as propeller shaft, centre bearing clamp & rubber, universal cross, yoke teeth and testing complete all as specified and directed by engineer-in-charge. each job 1.00 15 centre bearing along with rubber set 1 16 gear liver kit complete each 1 17 synchronizer ring set 1 18 gear reverse pinion complete set 1 19 assy brake fluid container each 1 20 assy timing belt with tensioner & idler each 1 21 writing of ba no with plate of vehicle on front and rear as directed each job 1 22 m&l for eicher 10.75 front windshield glass each 1 23 main fuel pipe ( fuel tank to filter ) each 1 24 seat safety belt nos 1 25 accelerator cable nos 1