installation of motor and allied accessories where bore wells constructed proj no 72 2023-2 od24037 / 2022-2023:pump bore well:supplying conveying , fitting, trial running and commissioning of electrically driven best quality reputed make bore well type submersible pump set with all accessories such as suitable size sheet metal panel board as per ie rules with main switch , fuse units, starter, power capacitors of adequate capacity, the pump should be stainless steel shaft and bronze impeller and all accessories such as starter volt ammeter , ampere meter , neutral link indicating lamps , earthing materials flcb single phase proven tor, sub merciless grade power cable of sufficient grade and connecting the section and delivery pipe to the-existing pumping main etc 3 18.48:providing and placing on terrace ( at all floor levels ) polyethylene water storage tank :isi 12701 marked, with cover and suitable locking arrangement and making necessary holes for inlet, outlet and overflow pipes but without fittings and the base support for tank. 4 50.18.7.5.2:providing and fixing pvc pipes, fittings including fixing the pipe with clamps at 1.00 m spacing. this includes jointing of pipes & fittings with one step pvc solvent cement and testing of joints complete as per direction of engineer-in-charge 40 mm dia 6kgf / cm2 - internal work - exposed on wall 5 50.18.7.2.2:providing and fixing pvc pipes, fittings including fixing the pipe with clamps at 1.00 m spacing. this includes jointing of pipes & fittings with one step pvc solvent cement and testing of joints complete as per direction of engineer -in-charge 20 mm dia 10 kgf / cm2- internal work - exposed on wall 6 18.17.2:providing and fixing gun metal gate valve with c.i. wheel of approved quality ( screwed end ) :32 mm nominal bore 7 50.18.8.1.2:providing and fixing pvc pipes, fittings including fixing the pipe with clamps at 1.00 spacing. this includes jointing of pipes & fittings with one step pvc solvent cement and testing of joints complete as per direction of engineer-in-charge concealed work, including cutting chases and making good the wall etc. 15 mm pipe 10kgf / cm2 8 18.54.1:providing and fixing ptmt bib cock of approved quality and colour.15 mm nominal bore, 86 mm long, weighing not less than 88 gms 9 od38168 / 2022-2023:providing fixingand tagging with 14 mm dia wire rope ( grade p e 100 ) hdpe pipe including jointing of pipe with mirror welding one step and testing of joints etc.complete as per the direction of departmental officers at site ( external work ) 50mm dia 10kg / cm2, 8gauge