bids are invited for repair and overhauling service - repairing of 3 phase 3000 rpm 150 hp kirloskar make induction motor at bpuram pumping station; as per atc; no; buyer premises - repairing of 150 hp kirlosker make 2950 rpm 440 volt, 3 phase induction motor at b.puram pumping station by repairing / replacing following items. dismantling the motor from chassis foundation, dismantling the complete motor for repairing, taken out rotor from the stator, remove burnt copper wire form stator cleaning the rotor and stator slots by portal, rewinding of stator of motor by high quality enameled copper wire including all required material i.e. latherised paper, cotton tape, insulation sheet, sleeve, empire tape, etc. with heating and blowing varnishes including making connecting lead with copper lugs, repairing of rotor seat and bearing housing seats of motor by welding turning and finishing as per required size checking straightness of rotor.02 job, providing and fitting bearing 6317 -01 no, beaaring n -317 - 01 no , repairing of cover by welding turning machining and fixing and fitting of sleeve as per rotor shaft seat of cover including labour and t&p charges -02 job , providing and fitting connection plate -02 job , providing and fitting fan as per s le. -01 job, assembling of motor complete in all respect p/f connection plate and connection lead -06 no. fitting motor on foundation coupling with pump with proper alignment including labour and t&p charges- ( including duduction of cost burnt copper wire removed from the stator of the motor ) , provoding and fitting coupling set after making hole as per pump and motor shaft with new stud, nut and bush etc , with all material labour and t&p charges complete in all respect.