bids are invited for facility management services - lumpsum based - as per rfp; as per rfp; consumables to be provided by service provider (inclusive in contract cost) - mild steel or iron work in heavy sizes such as trusses built up gates, door frames, record, racks roof work gates etc. wrought to required form including holes rivetting or welding where necessary and also fixing in proper position and alignment including cost of all materials supplied by contractor. , tmt/tor steel in plain work such as reinforced concrete or reinforced brick work (when not included in an over all rates) wrought to required shape as necessary including bending for proper completion of the work and including supply of steel its wastage, bend, hooks and authorized overlapping shall be measured. (steel shall be arranged by the contractor) , supply and fixing 6mm thick polycarbonate multiwall sheet ,fixing in position with j or u bolts 10 mm. dia with g.i. limpet & bitumen washers including supply of all materials, labour,wastage. and t&p etc. required for proper completion of the work. , rcc work with cement, approved coarse sand and 2 cm gauge graded approved hard stone ballast like granit, quartzite etc from dalla, jhansi or other quarries in proportion 1:2:4 in lintels of doors and windows, excluding supply of reinforcement & its bending but including its fixing and binding the same with binding wire, including cost of all other materials labour and t&p. , painting or varnishing new iron work in small areas or new wood work with one coat of ready mixed priming paint and one coat of approved superior quality ready mix paint luxol or equivalent brand or varnish including supply of all materials, labour and t&p etc. required for proper completion of the work. paint to be used should conform to the i.s. 103-1950. , as in item 5 above but for every coat after first coat. , supply and intallation of 2 hp single phase sewage submersible pump crompton,stpm 22 make including cost of labour, t&p and material required for completion of work. , supply & installation of 1.5/2 h.p pump set single phase electrical control panel of l&t / havells or equivalent make for submersible pump / pumpset containing contractor relay condenser. , s/f welded wire mesh size 75x25mm and rectangular made out of 10 swg over m.s. angle frame with m.s. flat welded as required including cost of drilling holes, washer welding etc as required including cost of all material, labour and t&p etc. required for proper completion of work . except cost of m.s angle and flat.