tender for dismantling wrought iron or mild steel work of any description not otherwise provided complete all as specified and directed , excavating in post holes (or similar holes) each n.exc 0.5 cum, getting out, returning, filling in and ramming earth or broken rubble mixed with earth around, in layers not exceeding 25 cm in hard / dense soil complete all as specified and directed. , m&l for plain cement concrete 1:3:6 type c2 using 40mm graded stone aggregate as in foundation of reinforced cement concrete post or struts complete all as specified and directed. , m&l for framed work in fencing including cutting tops to shape as directed, drilling holes, notching for wire, etc.; flat iron fillets (for securing wire mesh etc.) including all necessary drilling, bolting or riveting, etc., and similar work conforming to fe-290 gde e-165 complete all as specified and directed. , m&l for preparation of new steel surfaces of any description, over 10cm in width or girth,not otherwise described and applying two coats of black enamel paint over a coat of red oxide complete all specified and directed. , dismantling plain or corrugated steel sheeting of any thickness as in roof coverings complete all as specified and directed. , m&l for pre- painted galvalume aluminum zinc coating gi based corrugated steel sheet 0.50mm thick of an colour having tensile strength of 550 mpa as in roof covering/cladding to wall, fixed with self tapping screws as specified complete all specified and directed. , demolition of reinforced cement concrete of any description and in any position not otherwise specifically provided complete all as specified and directed. , m&l for reinforced cement concrete nominal mix 1:2:4 type b1 (using 20mm graded crushed stone aggregate) as in foundations, including rafts, footings, foundation beams; plinth beams; bases for columns, etc.; basement slabs, under-reamed piles and mass concrete, complete all as specified and directed. , use & waste of form work to sides of concrete foundations, footings, bases of columns, raft and raft beams, sides and soffits (if any) of foundation and plinth beams; and similar work; vertical or to batter complete all as specified and directed. , m&l for reinforced cement concrete nominal mix 1:2:4 type b1(using 20m graded crushed stoe aggregate) as in columns, pillars, piers, posts and struts, complete all as specified and directed. , use & waste of form work formwork to sides of pillars, posts, struts, piers, columns and stanchions, complete all as specified and directed. , m&l for reinforced cement concrete 1:2:4 type b1(using 20m graded crushed stoe aggregate) as in beams, reinforced cement concrete bems lintels etc, complete all as specified and directed. , use & waste of flat formwork to sides and soffits of floor or roof beams, beam haunchings, girders, bressummers, lintels, cantilevers, shelves including sup- ports, overhangs, etc. also splays between floors and beams, etc. , m&l for mild steel tmt bars 10mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips , complete all as specified and directed. , ditto, but 5mm dia and over upto and including 10mm dia in stirrups, spacers and binders, complete all as specified and directed. , demolition of brick/precast concrete block walling built in cement mortar, complete all as directed. , m&l for precast cement concrete block (1:3:6 type c1, using 20mm graded crushed stone aggregate)masonry with solid blocks, exc. 10 cm in width and setting in mortar1:6, complete all as specified and directed. , m&l for 15mm thick rendering in cement mortar 1:6 on concrete surfaces of wall, finished the surface even and fair, complete all as specified and directed. , m&l preparation of new plastered surfces of wall and applying two coats of cement base paint over one coat of primer, complete all as specified and directed.