tender for punjab water resources management & development corporation mansa pwrmdc division, mansa estimate for lining/relining by laying ugpl of w/c of o/l rd 35020-r of moosa br. of bhikhi disty of village mansa kalan of district mansa. dnit 08/2026 dated 17/03/2026 name of firm sr.no description unit rate (in figures) rate (in words) , excavation by mechanical means(jcb or hydraulic excavator) in trenches for pipe lines with straight or open cutting in streets or open area including trimming and dressing sides levelling of beds of trenches to correct grade, cutting joint holes, refilling consolidation, watering , including the cost of dewatering of rain water, diversion for traffic,night signals. providing & fixing caution boards, crossing over trenches for access to the houses, watching, fencing, etc. and removal of surplus soil out side/inside the town involving lead upto 15 meter complete in all respect. (a) earth work upto 1.5 m. depth cum 29 (b) exceeding 1.5 m depth but not exceeding 2.25 m depth cum 29 (c) exceeding 2.25 m depth but not exceeding 3.00 m depth cum 29 , earth work excavation in foundation,trenches etc.in all kinds of soil where pick jumper is not involved & not exceeding 2 mtr. depth including dressing of bottom & sides of trenches taking the excavated soil clear from the edge of the excavation. , first class burnt brick laid in cement sand mortar 1:6 for bed and side wall [item no 11.3(i)]. , 10mm thick cement plaster 1.4 on sides walls (-) rs.1.25/- for scaffolding. , 10mm thick cement plaster 1:4 on bed and top. , reinforced cement concrete 1:2:4 hand mixed but including steel reinforcement (csr item no 10.13 (a) (i) , cement conc.1:2:4 including supply, carriage & with stone ballast or shingle , cement concrete 1:4:8 with brick ballast 40mm gauge , lowering, jointing and cutting of reinforced cement concrete pipes 700 mm dia for vent pipe into trenches and laying same to correct alignment ( @2.50 metre / no) , lowering, jointing and cutting of reinforced cement concrete pipes 150 mm dia for vent pipe into trenches and laying same to correct alignment ( @2.50 metre / no) , wrought iron and mild steel ladders, framed grills, grating etc. complete fixed in position in d-tank.(csr 2020 item no.18.4) , providing & fixing m.s. foot rests made of 23x25 mm square bar including fixing in haudis complete with cement concrete 1:2:4 (csr 2020 item no.29.35 ) , providing and fixing of alfa alfa valve fitted on riser pipe to act as nakka (d regulators) dia-700 mm , centreing & shuttering for concerte faces , providing and fixing of steel shutter gates assembly in main pipeline complete in all respects dia-700 mm , dismantling of brick work in cement, csr 2020 - item no- 8.5 (b) , any other item