supply of lathe and driiling lab equipments - 1.01 all geared lathe ( 4-½’ ) ncapacity ncentre height : 165mm nswing over bed : 325mm nswing over cross slide : 175mm nswing in gap : 500mm nwidth of bed : 225mm nlength & between center : ( 4-6 ) 1370mm / 660mm nmain spindle ntype of spindle nose : threaded nspindle bore : 38mm nspindle morse taper : mt-5 nspindle adapter morse taper : mt-3 nspindle speeds ( nos ) : 8 nrpm range : 54, 90, 140, 224 315, 500, 775, 1200 rpm ntail stock spindle nspindle diameter : 38mm nspindle travel : 120mm nspindle morse taper : mt-3 nleading screw : diameter / threads : 25.4mm / 4 tpi nnos. of threads / range ( for fully norton gear box ) : metric : ( 17 ) 0.5mm to 15mm pitchinch : ( 40 ) 2 tpi to 60 tpi nstandard accessories n• flame hardened bed ways n• spindle sleeve n• dead centers 2 nos n• tool post key n• motor pulley n• thread dial indicator n• change gear set ( for metric and inch ) nmachine supplied along with n• 2 hp 3phase motor n• 6”x3 jaw chuck n• panel board n• splash guard n• norton gear box n• taper turning attachment n• coolant assembly n• steady rest n• follow rest n• live centre nnote : n• base of the machine is defect free high quality close grained cast iron and slide ways are ground finished to ensure high accuracy n• the slide ways are closely scrapped, hardened and matched to achieve maximum accuracy and surface finish. n• all the shafts and screw ismade out of alloy steel. n• geometrical and practical tests will done as per indian standards of latest edition on the spot at the time of installation. necessary inspection and material test certificate will be submitted. n• machine operational manual will be produced at the time of delivery n n