tender for t/f protection and other work under nagar nikay under ee, edd, haidergarh barabanki. - safe loading, carriage including unloading and proper stacking of following materials from central store barabanki / je store to site of work. 2 ltxlpe cable 1x240 sq.mm. 3 earth rod 2540x20 mm 4 gi wire 6 swg 5 laying of lt xlpe cable 1x240 sq. mm (xlpe cable will be provided by the department) 6 earthing of pole with ms earthing. 7 provinding & fixing of various type materials. all materials shall be supplied by the contractor. 8 construction of lt distribution cum lt protection piller box in rectengular shape made of ms angle of size 50x50x6 mm, 7.5 mtr. long for installation of henley type tailless fuse unit 300 amp 650 volt 3 nos. outgoing circuits with copper bus bar of size 1000x50x6 mm including proper grouting of structure by digging of pits of size 300x300x600 mm with the help of cement, coresand and agreegate in the ratio 1:3:6 and fabrication of structure complete. 9 alluminium lugs long barrel 240/400 sq.mm. 10 alluminium lugs long barrel 120 sq.mm. 11 copper l-piece 12 nuts & bolt with washer 13 supplying and filling in plinth withsand under floors, including watering, ramming, consolidating and dressing complete.(d.s.r.2.27) 14 providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - all work up to plinth level :1:5:10 (1 cement : 5 coarse sand (zone-iii) derived from natural sources : 10 graded stone aggregate 40 mm nominal size derived from natural sources) (d.s.r.4.1.10) 15 providing and laying factory made chamfered edge cement concrete paver blocks in footpath, parks, lawns, drive ways or light traffic parking etc, of required strength, thickness & size/ shape, made by table vibratory method using pu mould, laid in required colour & pattern over 50mm thick compacted bed ofsand, compacting and proper embedding/laying of inter locking paver blocks into the sand bedding layer through vibratory compaction by using plate vibrator, filling the joints with sand and cutting of paver blocks as per required size and pattern, finishing and sweeping extra sand. complete all as per direction of engineer-in-charge.80 mm thick c.c. paver block of m-35 grade with approved colour design and pattern.(d.s.r.16.91.2) 16 repairing work of cable trech and top cover plate made of pcc and fabricate and filling of sand in the trech. 17 repairing work of control room roof with providing all material and labour. 18 painting of structure of switch yard with providing all material and labour. 19 painting work of control room with providing all material and labour. 20 repairing work of fencing with providing all material and labour.