improvement of water supply by replacement of enm equipment for various sites in rajender nagar area . - .01 disconnection of main electric supply dismantling removing the pump and motor set lifting on the safe place dismantling of sluice valve non return valve, delivery pipe lines with the help of heavy man power chain pulley block as per site requirement. item1 7 job 2 1.02 supply of automatic lt panel board suitable for 415 volts , 3 phase , 50 hz , 4 wire system for operation of up to15 hp submersible set, made out of not less than 2mm thick crca for load bearing members, and 1.6 mm for doors of panel, totally enclosed , dust and vermin proof , floor mounted type .the panel size 760mmx1360x300mm and having 1 ) 63 amp change over-1no.2 ) 63 amp tpn mccb – 1 no.3 ) amp. meter 0-50 a-1no.4 ) volt meter-1no.5 ) amp.& volt meter selector switches- 1 set. 6 ) auto manual+ light+ control mcb tp 32 amp- 1 no. each 7 ) ct-3nos 8 ) push button +on / off light-2nos each 9 ) 5 kvr shunt capictor-1no. 10 ) aluminum bus bar size 25 mmx6mm-1 set. 11 ) 15hp star delta starter a ) 32 amp power contactor -3no b ) over load relay 14-23 amps. 1 no. c ) star deltatimer 1 no. d ) qt timer -24 hours -1 no. e ) motor protection relay flush mounting with display with thermal o / l , short circuit, earth fault, phase loss, unbalance, phase reversal, locked rotor protection make l&t / protech -1 no. nmake of accessories / components as per djb approved nmake of panels:-l&t / c&s / bch / protech n item2 7 nos 3 1.03 supply-of bore-cover plate of size: 200 mm dia, made out from 6 mm thick m.s.-sheet in 2-halves and a circular-hole of 50 mm dia in center with locking arrangement by nuts & bolts. item3 7 nos 4 1.04 supply-of g.i. bend 90o x 50 mm dia, having flange at both-ends. item4 7 nos 5 1.05 installation of pump and motor, automation panel, sluice valve nrv valve on delivery side pipe and flange nut bolt washer the job i / c all tools and tackles , safety equipment’s and other precautions etc. for each t / wells. item5 7 nos