tender for maintenance work of circle office building at meerut ; 2 brick work with common burnt clay f.p.s. ( non modular ) bricks of class designation 7.5 in foundation and plinth in: cement mortar 1:6 ( 1 cement : 6 coarse sand ) [ m3 ] 3 dismantling doors, windows and clerestory windows ( steel or wood ) shutter including chowkhats, architrave, holdfasts etc. complete and stacking within 50 metres lead of area 3 sq. metres and below each 4 providing and laying 60mm thick faciory made cement concrete interlocking paver block of m -30 grade made by block making machine with strong vibratory compaction, of approved size, design & shape, laid in required colour and pattern over and including 50mm thick compacted bed of coarse sand, filling the joints with line sand etc. all complete as per the direction of engineer-in-charge. 5 providing and fixing precoated galvanised iron profile sheets ( size, shape and pitch of corrugation as approved by engineer-in-charge ) 0.50 mm ( + 0.05 % ) total coated thickness with zinc coating 120 grams per sqm as per is: 277, in 240 mpa steel grade, 5-7 microns epoxy primer on both side of the sheet and polyester top coat 15-18 microns. sheet should have protective guard film of 25 microns minimum to avoid scratches during transportation and should be supplied in single length upto 12 metre or as desired by engineerin-charge. the sheet shall be fixed using self drilling / self tapping screws of size ( 5.5x 55 mm ) with epdm seal, complete upto any pitch in horizontal / vertical or curved surfaces, excluding the cost of purlins, rafters and trusses and including cutting to size and shape wherever required. 6 steel work welded in built up sections / framed work, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer using structural steel etc. as required. in gratings, frames, guard bar, ladder, railings, brackets, gates and similar works. 7 provision for 12mm thick cement plaster 1:4 ( 1 cement: 4 coarse sand ) including carriage of water & material etc 8 finishing walls with water proofing cement paint of required shade. new work ( two or more coats applied @ 3.84 kg / 10 sqm ) sqm 9 distempering with 1st quality acrylic distemper ( ready mixed ) having voc content less than 50 gms / litre, of approved manufacturer, of required shade and colour complete, as per manufacturers specification. 10 painting with synthetic enamel paint of approved brand and manufacture of required colour to give an even shade.two or more coats on new work over an under coat of suitable shade with ordinary paint. 11 provision for sanitary work and plumbing as per direction of engineer-incharge ( the details collected by sub circle incharge ) . 12 providing and laying vitrified floor tiles in different sizes with water absorption less than 0.08% and conforming to is: 15622, of approved make, in all colours and shades, laid on 20mm thick cement mortar 1:4 ( 1 cement : 4 coarse sand ) etc., complete. 13 cement concrete 1:2:4 ( 1 cement : 2 coarse sand : 4 graded stone aggregate 40 mm nominal size ) in pavements, laid to required slope and camber in panels as required including consolidation finishing and tamping complete 14 dismantling old plaster or skirting raking out joints and cleaning the surface for plaster including disposal of rubbish to the dumping ground within 50 metres lead