tender for work for transformer linkage, gasket etc, under edd-ii baraut, work related to control panel, gasket repair etc. installed at power substation-iv in the jurisdiction of power distribution division-ii, baraut, open and separate all cables and conductors of the power converter. drain oil as per requirement from the power converter and pour it into the drum. disassemble all the radiators of power converters. stopping leaks by welding radiators of power converters. replacement of all radiator and wall gaskets of power converters. complete the work by opening the top plate of the power converter, replacing the gasket and installing the top plate. completion of replacement of damaged 33 and 11 kv bushing rods of power transformers. completing the work by changing the gaskets of box wall, conservator tank and die foam of power transformers. completion of replacement of gaskets of 33 and 11 kv bushings of power converters. after completing all the work of power converters, top up the oil in the converter and start the supply by installing all the cables and conductors. note 1. all work will have to be done as per respo standards. 2. the quantity of the above work number 01 to 10 is completely estimated and can be changed according to the requirement of the work. also the quantity of work can be from zero to maximum (within the limit of tender amount). 3. as per the orders of the competent officer, work can be done in any section/sub-section under the electricity distribution board, baghpat. 4. in case item wise prevailing/market rate is not obtained in the above work, item wise negotiations will be conducted.