repair work of damaged lines in areas fed from 33/11 kv substation bharthana under electricity distribution section ii, etawah - carriage of pcc pole 8.5 mtr. long from store center kunera etawah to site of work through the kacha and pakka road including the work of its loading and unloading at the respective ends including the cost of arrangement of labour, t&p, carrier etc. required for proper completion of work. 2 carriage ofstp-55 11 mtr. longfrom store center kunera etawah to site of work through the kacha and pakka road including the work of its loading and unloading at the respective ends including the cost of arrangement of labour, t&p, carrier etc. required for proper completion of work. 3 safe carriage ofline materialfrom store center etawah to site of work. including loading & unloading at both ends. including the cost of arrangement of labour, t&p, carrier etc. required for proper completion of work. 4 erection grouting, concreting and plinting of single support on pcc pole 8.5 mtr. long with cement, coarse sand & stone ballast duly grouted including necessories clamps, accessories required fixing of ht/lt fittings as per resspo norms. the support shall be grouted in cement, sand and brick ballast. it including the cost of all labour, t&p etc. required for proper completion of work. 5 erection grouting, concreting and plinting of single support on stp-55 11 mtr. long with cement, coarse sand & stone ballast duly grouted including necessories clamps, accessories required fixing of ht/lt fittings as per resspo norms. the support shall be grouted in cement, sand and brick ballast. it including the cost of all labour, t&p etc. required for proper completion of work. 6 installation of stay set with grouting and nuzzling etc. as per resspo drawing /norms along with all routine material to be used for such works. 7 earthing of poles by fixing earthing rods and binding with earth wire as per standard norms including cost of labour t&p and required material for such work. 8 laying, sagging and stringing and jumpering / binding etc. ofacsr weasel conductor in 11 kv/ lt lines as per resspo manual and as per direction of executive engineer including the cost of arrangement of labour, t&p, carrier etc. required for proper completion of work 9 re-sagging of old loose 11 kv/l.t. line as per direction of executive engineer. it includes the cost of labour, t&p etc required for proper completion of work. 10 re-nuzzling of old stay set by opening old binding for better straightening of pole and re-sag the existing conductor of 11 kv/l.t line properly as per direction of supervising engineer. 11 straightening of pcc/st/rail pole tilted poleat various places by straighteningof pole including the cost of labour ,t&p charges required for proper completion of work. 12 chopping of tree branches to clear the line route to give horizontal and vertical clearance to the line including cost of labour t&p etc. 13 replacement of following broken/damaged/ missing accessories by new accessories including opening of the same and refixing. 14 11 kv pin insulator with pin 15 11 kv disc insulator with fitting 16 11 kv v type cross arm 17 11 kv cross arm for pcc pole 18 11 kv f clamp for pcc pole 19 nut bolt with washer off size