tender for community building construction work, sadhuna near laluram bhambhus mansion. - excavation of soil upto 1.5 depth in foundation, trench, drain, tamping the bottom, pouring water, beautifying the sides, taking out the excavated soil, filling the empty spaces with soil again after filling the foundation and disposal of the remaining soil upto a distance of 50 meters.2 putting 40 mm nominal size stone aggregate (crusher broken) brick aggregate in cement-sand mixture in the ratio of 1 cement: 4 sand: 8 aggregate and tamping, including tamping.3 laying of stone in foundation and plinth in cement-gravel mixture, including closing the side gap and tamping etc.4 additional amount in masonry in superstructure in item number 4 upto 4.5 meters height from plinth level. 5 supply and casting of reinforced cement concrete of 1:1.5:3 mix, pressing, tamping of roof slabs, eaves, beams, lintels etc. and levelling of surface with 1:3 cement mortar etc. including scaffolding but cost of steel and shuttering separately.6 supply of cutting, bending and fixing of iron at place and fastening work for rcc work. 7 centering shuttering (platform and casting) for laying rcc roof, slab, balcony, lintel etc. up to 4.5 m height and removal etc. as per specifications.8 laying of roof of top quality stone strips, filling with cement mortar in 1:4 ratio with stone arch at joints from top and bottom 2.4 m to 3.0 m span9 brick trench over the roof of strips, giving a slope of 1:50 in average thickness of 100 mm, using 25% lime in it, crushing and plastering work complete in all respect. in case trench is made of less than the prescribed thickness, 10% amount of total cost should be deducted for every inch less thickness.10 cutting and mounting of iron girder and fixing it at the place up to 4.5 m height. note: - analysis 6 m length and size 200 x 100 mm. (37.7 kg per meter)11 supply of 1 meter wide and 2 meter high double-leaf door of 22 gauge plain sheet, with 40x40x3 mm angle iron frame and 25x25x3 mm angle iron frame of the door as per drawing no. 14. with angular sliding bolts, latches and catch strips.12 20 mm cement plaster on wall using cement-gravel mixture in 1:6 ratio, including scraping and tamping of joints.13 section window as per drawing and design (pwd item reduced by 10%)14 window15 wire mash16 grill17 soil work in filling18 in cement concrete foundation or floor, put 40 mm nominal size stone aggregate (crusher broken), brick aggregate, cement-sand mixture in the ratio of 1 cement: 5 sand: 10 aggregate and crush it, including tamping.19 laying mosaic tiles on the floor over cement gravel mixture of 1:6 and filling joints with 1:3 cement mixture and leveling them etc.