safely carriage ofpcc poles (8.5 mtr. long) from esc, sre to site of work including loading & unloading at both ends.. 3 safely carriage of other complete line material(except pcc poles) from esc, sreto site of work including loading, unloading at both ends 4 safely carriage of new 250 kva t/f from esc, sre, to the site of work including loading & unloading at both ends. 5 erection of d/p on pcc poles (8.5 mtr. long) with complete fitting of all accessories. 6 providing of aluminiumlug 250 a. 7 safely carriage of fuse set from esc, sre, to the site of work by including loading & unloading at both ends. 8 safely fixing of fuse set properly. 9 safely carriage of tpmo set from esc, sre, to the site of work by including loading & unloading at both ends. 10 safely fixing of tpmo set properly. 11 providing of all type clamp with nut and bolt as per respo specification. 12 concreting of pcc pole with cement concreting in block of 600x600x1500 mm in ration 1:4:8 with cement sand and brick ballast size 1x1.5 sq mm. 13 grouting of 11 kv stay rods by digging of pits in block of 600x600x300 mm. and nozzling of stay wire 7/10 swg and fitting the same on the pole 14 constriction of plinth for installation of 250kvat/f of size 1.5x1.5x1 mtr made of 9”inch thick wall in all four sides with 6”inch thick rcc top duly filled with sand and plastered 12 mm thick in ratio 1:4 with cement and sand on outer surface of brick wall as per respo specification. 15 safely installation ofnew 250 kva t/f on the plinth with proper alignment and complete fitting including making connection and commissioning 16 safely carriage oflt abc cable 3x120+1x95+1x16 sq.mm from esc, sre to site of work including loading & unloading at both ends.. 17 laying, lifting, stringing, proper sagginglt abc cable of size 3x120+1x95+1x16 sq.mm. including fixing ofall type clamp and connector of all accessories. 18 earthing of 250 kva t/f (1 no body & 1 no. neutral earthing) by boring 60 fit deep with providing & fixing ofg.i pipe 1½” dia (jindal class b) and connecting with g.i. strip of size 40x5 mm and g.i wire at bottom of g.i pipe to the t/f providing of required charcoal & salt in the pipe 19 providing & making of wiremesh fencing size 2.5x2.5x2.5 mtr with grouting making frame of ms angle 40x40x6 mm and fixing four no msstrip size 25x6 mm at equal distance in between the frame and fixing square mesh of 50 mm squre in each frame the fencing should cover all side of t/f with providing 1 no door size 6x3 with sitakni & dandala with green paints (british/asian/enamel paints)